开云体育

Not to mention that if you put a circulator on the packet radio, it will pass transmit, but any receive signal will get ported to the dummy load.

I thought Andrew stopped making LDF a long time ago. Where are they getting it?

We're making the trip again all the way from Southern California. Assuming we get there, we'll have a variety of gear available including; four lowband Syntor X9000's with cables and control heads,

Guys,? I have several pieces of galvanized 7-strand steel antenna guy wire that are looking for a new home.? If anyone here wants a piece, I'll bring it with me to my fleamarket space at the

FYI I have many GE 10 volt regulator modules if anyone wants them for $25.00 ea., shipped UPS included. Regards, Charles F. Adams K3HKZ Industrial Communications Co. 121 N Sitgreaves Street Easton, PA

tessco.com is one dealer that has a lot..... and they can be? "mighty proud" of them also (when it comes to price).... at least it allows you a reference to compare against

You have to tell us what exactly you are looking for. Connector type, gender, etc. Matt AL0R Sent: Thursday, May 8, 2025 20:30 To: [email protected] Subject: [repeater-builder] Heliax center

I am looking for center pins for Andrew Heliax connectors for both 1/2 inch LDF4-50 and 7/8th inch LDF5-50.? Male or female. Thanks de David, K5RAV

Sounds like you are losing your TX OSC Control +10V. You can watch that line in the fold down tray on the exciter pin header with a volt meter. If that is is case remove the power supply card and put

I can usually find good deals on eBay. Dave Bates

I just use the PSA series of male and female N connectors . No soldering. Dave Bates, KF?XQ [email protected]> wrote:

What connector? Joe, K1ike

Have you watched the 10 volts to make sure it's not changing? Joe, K1ike

You might try the RF Connection in Gaithersburg, MD. https://rfconnection.com/ RodN8RAT

for what type of cable?????

Does anyone know of a source for Andrew Heliax connector center pins?? Thanks de David, K5RAV

It is a GE Master II station. ?This is the rack style with the receiver fold down drawer and the card slots on the top. ?The controller is an RC-210. ? This has worked for years with no issues, and

It helps if we know what repeater it is. Sounds like a ge Mastr iI?What controller are you using. Is this a new issue on an existing ?system?or a. We repeater. That your putting together ?Neal

Need some help debugging our repeater. Here are the Symptoms: 1) transmit drops out after 3-4 seconds. 2) TX led on 10V regulator control card stays on another few. Seconds after TX drops. 3) as long

The isolator is likely doing little to keep the FM out of the repeater transmitter. Isolators only provide a significant degree of directivity within a fairly narrow range. Given the wide frequency