开云体育

The problem is UV stability. I read in their documentation somewhere that the outer jacket isn't really UV stable. So look back at it again in 8-10 years.

Processor? Ram? HDD or SSD?

HP-T5000 [email protected]> wrote:

Superflex is a form of Heliax. Joe, K1ike

From the Commscope web site regarding FSJ-450B (1/2"superflex) ----------------------------------------------------------------- "Jacket Material: PE Outer Conductor Material: Corrugated copper

You may have wanted to move the cable side in the vehicle to get a good match. That was what I had to do. Mick - W7CAT

Hello Gervais, The Larsen kg-270 is a very good glass mount but they have gone completely crazy on the price. When I was installing mine, I used some packing take to hold it in place and look at the

well, i dont have much choice on my Rav4 2009, on the rear i have a fiberglass spoiler,,i dont want an hole. i am stock with the glass mount on the side ,a compromise situation. gervais

hello tedd, yes i add one of these long time ago ? , there is a little screew to adjust the SWR at the low point. i just found one here in my scrap yard ? ,,an old Larsen that i have no idea the

Hi Gervais, I have 2 of these from years ago. They are very old stock, but are complete. They are marked 144-148 and 440-450. They have an adjustment on the internal box. There are no other marks on

If it is this type of Superflex, it might be fine. https://www.solidsignal.com/rfs-1-2-inch-50-ohm-superflex-coax-cable-15225330 But most of us refer to Superflex as something that is more like

You really should consider Heliax over Superflex. All the Best & 7 3s Dale Miller, KC2CBD Cookeville, Tennessee Putnam County TN ARES Emergency Coordinator Vice President Cookeville Repeater

That may be so Milton but I've had half inch superflex running to my HF and VHF antennas for over 4 years without any issues.. if it can stand the Texas heat it can stand anything LOL Chris WB5ITT

Consider a trunk lip mount. I have used these on hoods and trunks as well as some other locations. Milt N3LTQ

Superflex is not intended to be used for exterior antenna runs. It was developed for interior cabling in shelters and racks where tighter bends were needed. Use regular Heliax for exterior runs. Milt

Roger and Gervais, I used a Larsen glass mount on my wife's 2001 Cadillac STS, until we had to replace the rear glass... Like Roger noted, the new glass must have been of a different "mix", as I could

yes roger,i think i have a special place on the side windows for that ,,it is molded in the glass or it was on the rear windo,, i will check thanks Gef ________________________________ De :

ahh way over my "retired man " budget andy, 250$ here at Radioworld.ca. des voleurs,,,, way to much for me gervais ________________________________ De : [email protected]

Hi Dale, Building say a 4 bay UHf array is not going to be as easy as purchasing one, (say DB products) used, and remaking the harness for your frequency, as was already stated. It may not be cheap

I May be interested but can we see specs on this device? [email protected]> wrote: