开云体育

Let me take a look, i usually justgoogle for an mfj2270b manual Bob

Hi Bob, I have a few MFJ 1270 units but do not know how to use them for the Network 105. Is There a guide or Youtube Video for guidance Please? 73 Mike vk4sy

Yes Steve What you mentioned appears to be correct when looking at the U.S. band plan. I am operational and beaconing on 28.135 USB at least today and maybe tomorrow, in case there be any interest in

I took the info from the IRU Region 2 bandplan... sorry - should have checked ARRL instead. Let me flip the question around then, is there any part in the 10m Band that allows FM and Data? If not then

Sadly we cannot in the US. If I'm not mistaken, we are limited to 28.0 to 28.3 for data on 10m. Above that is phone and image only. But I would love to try 2400 baud sometime, too. :) Steve K4RVA

Do me a favor and let me know when and on what frequency everybody is going to do this so I can get the word out on other packet groups. Maybe we can do a monthly QSO party on a specific (or rotating)

no objection, 28.135 sounds fine. We could also go higher and try FM? 29200-29300 6000 All modes ACDS I remember playing with 10m FM with VP9NO - I believe we even got a connection with 2400 baud

I'm in! :) Just let me know the frequency and whether LSB or USB. I think last time we used 28.135 LSB (dial frequency) because it fell within the portion of the band which allows for automated

Hi Marcel If I recall I think we congregated up around 28.135USB? I used one of the SCS Trackers in 1200B mode for that, but not long after, I broke one of the male pins on the 6pin din connector,

I wouldn't mind firing up packet and playing some more with 1200baud on 10m or other bands. Anyone else interested? 73 Marcel

Last year we did a couple days of experiments on 10m. I managed to leave a msg into VA3UKW-1 BBS, as well as another state side contact. We used USB 1200B. It was my thought that because of 1200 B's

Thanks for the reply i will take a look….. right now i am using a hw tnc because i have a stack of mfj1270’s Bob

Thanks Chris B

Whoops, I meant Bob. See my prior post, Chris and I actually experimented with this, and it's just a matter of adoption with people agreeing on dual Soundmodem (Windows folks) decoders, and/or the

Hiya Chris, I actually re-started this discussion just about a year ago :) Sadly, due to hurricanes, I've been off-air (rip G5RV) for the past 6 months

Welcome to HF Packet, Bob. Network105 traditionally uses 300 baud AX.25, however, due to the limitations being lifted there have been members here experimenting successfully with 600 baud and higher.

New here, so sorry if this is a rehash……. I have been running packet on U/HHF for a long time so typically 1200 or 9600 rate, but i am trying to extend my node reach and looking at HF, ?typically

Hi all, new version available: =============================== KAM XL Update - Firmware / Bios V 1.24160 Released August 2024 ====================================

Those that do not have the time to hang onto the mike for a contact miss out on the hobby’s intent and purpose – human contact. And when disasters strike, the human element becomes paramount. I

Thanks for the suggestion. Downloaded and tried coolterm … can’t get it to work properly though, after the first command each line just starts with a “.” and it doesn’t seem to recognize any