开云体育

OK after some head scratching and deep reading, the fix is simple. kcat uses obsolete method main.get_frequency. The new method is rig.get_frequency. I changed that in src/support/xml_io.cxx and now

Once the port is configured, could you perhaps ln -s the file .fldigi/talk/output.txt in your home directory to your serial device /dev/ttyUSB0? Everything's a file in Linux.

In the Misc section of the FLDIGI configuration you can choose 'RX text capture' and enable 'rx text stream' in the window that pops up. That stream goes by default to .fldigi/talk/output.txt in your

Sure: cat textout.txt > /dev/ttyUSB0 --David KI6ZHD

Nice! That is a bit easier to use, and I did not find it. Any way to redirect that directly to the serial port? (USB) Sent: Friday, April 18, 2025 1:29 PM To: [email protected] Subject: Re:

Look at the $HOME/.fldigi/talk/textout.txt file --David KI6ZHD

Greetings: I have setup an RTTY -> phone -> modem ->ASR-33 demo here at the Computer Museum @ System Source (Hunt Valley, MD) ( https://museum.syssrc.com ) I am taking an RTTY Feed, (for example

Tried a couple earlier versions, including 4.1.17 from 2020. Same behavior as the newest version. So I guess it's nothing in the new code that broke it. And maybe I'm dreaming that it ever

Hi Dave. Not seeing the accumulated logs (and a lot of other problems) maybe a result of that change some years ago to use $HOME/.fldigi/.fldigi when it was previously just $HOME/.fldigi eg my older

I found Dave's archive of tarballs. I'll try some of those to see if going back fixes this.

I use kcat all the time and it works great. I use fldigi only now and then. But I built fldigi from source yesterday, to get all the new-and-improved, all looked clean. But now doesn't work with

Hi again. OK, I've tried every which way and then some. I can get the new .07 alpha to restore my station and operator details, the view window layout (including the "show all 48 macros" setting)

The Country (CTY) Files were updated on 12 April 2025: https://www.country-files.com/cty-3511-12-april-2025/ For installation instructions, start at: https://www.country-files.com/ Hover

When I connect fldigi to be controlled via flrig (ft-817), flrig closes unexpectedly. It even opens the window to report the problem via bugzilla. I can only use Flrig if I am disconnected from

This is not a font change Dave, but a translation table change. The missing character will be the pound sterling symbol. [image: image.png] The translation change is for the " ' " and bell

Built and runs OK, but ... a)??? Not sure where the new font choices appear, I can't see anything new listed in the config font menu choices relating specifically to RTTY. That, and more

This has been sold. Thank you for the bandwidth. Joel, W4JBB

Still finding "experiments." I have a RPi 5 with 8 GB RAM. It also has a Raspberry Pi Foundation active cooling fan and third-party daughterboard (SupTronics X1000 v1.5) for an M.2 NVME SSD. Includes

If you are encountering lag and freezing with FLDIGI after upgrading to Bookworm, the issue may be with the Wayland display server native to that operating system. Reverting to X11 may resolve the

The Country (CTY) Files were updated on 06 April 2025: https://www.country-files.com/cty-3510-06-april-2025/ For installation instructions, start at: https://www.country-files.com/ Hover