开云体育

Thanks I tried that and destroyed 2 DIN connectors in the process trying to solder wires onto those tiny pins. I was hoping there was one already made like for my ICOM radios. I found one on eBay

Jerry, I have the same setup. You just need a PTT cable from 991A to LA-1K.? I am using 8 pins DIN plug and RCA plug in the other end. It will be pin 2 TX GND and pin 3 GND.? More in for can be

Does anyone here know what cable is needed to connect the LA-1K to the Yaesu 991A?

If anyone in the group knows of someone looking for a like new pristine LA-1K. Let me know off the reflector and I will put you in touch. Neil n4fn "at" arrl.net

If you get on CW you MUST have delay. Try it at low power int a dummy load and you should see what happens. If you have chatter you need delay. 73 Happy to help anytime Neil

Neil, thank you for your help and all of the trouble looking for the 991A set up. Yes, that is all pretty much I can see on my 991A manual. I guess I don't have to worry about it so much.? I only

I downloaded the manual for the FT- 991A, and it talks about the delay on pages 78 and 79. Further explanation of *hang time* is on page 85 under the heading of ""CW Time Delay Setting". I hope that

Komkit, This is from the Ftdx5000 manual I suspect you have something similar in the 991 manual. I will see if I can find it. 73 es gud dx Neil N4FN [image: image.png] [email protected]>

Komkit, As far as the discussions I have had with Paul at Palstar (Paul and Eva have been dear friends for many years, sadly I will miss having dinner with them at Dayton because at 85 the trip has

The LA-1K is NOT a QSK amp, so when running CW you must enable some hang time delay other wise the relay will be damaged. On my FTdx5000 this is enabled with the vox delay. This does mean you are

I think somewhere on this forum Paul, the creator of the amp, said that the vacuum relay in the amp will not switch until it senses RF. So no TX delay is required.? N1UB

Neil, The call here is W3KIT, sorry about not posting it down. Thank you for the reply. At any rate, very good to hear that I don’t actually need the ALC cable.??I am not an avid CW operator, I

You do not need it (ALC cable). The TX delay on the Yaesu is important since the LA-1K is *_NOT_* a full break in amp it is set on the VOX control (at least that is the way on my FTdx5000) and I

Do I really need it?? Just got the LA-1K, not sure if I need it or not. I am also at lost about TX delay thing in the manual.? Currently I have just keying cable connected to the amp. I will be

I also use the software from TRX-Manager thanks to Paul. It works great for me since I can not easily see the front panel of the LA-1K Neil N4FN [email protected]> wrote:

Tnx Paul, will check it out......

Fyi Joe if you are looking for software to manage the LA-1K check out the TRX-Manager site. I use it to manage the LA-1K remotely. Good luck and 73 Paul NO0T Paul Sobon 1700 Bassett Street,

have fun ?gd dx 73

Kelly.. Got it to work. Tnx agn, best 73...... Joe --------------------------------------------

Joe Go to the Palstar site and bring up the LA-1K page, scroll down and see this file 5.*Download*LA-1K Firmware: * *LINK: LA-1K FIRMWARE 1.03H.ZIP*