开云体育

Yes.? What Jan and Tom said (in his second thoughts) would be solve this problem 100%.

I merged something similar to the suggestion below while doing the JMRI 4.14 update. I dialed it back a little bit, as it ended up being somewhat repetitive. Repetition can help understanding, but it

Let's start at the beginning. Defined the JMRI connection to the SUSIC which is built with the RS232 parts to match the match the Keyspan. Baud rate and card configured to address 0?? Or is there an

Dave, If you made a mistake you think anybody else might make, let us know. It might serve to help others avoid the same hang up. It is like the OpSig rule: Only make new mistakes. -Ken Cameron,

Hello Tim, Creating a clean loop sound could be challenge. I also have the experience that taking a zero crossing point may be insufficient. Another cause for a "bad click" could be a bug in a JMRI

Hey Sorry Guys, found my mistake. Got it working now. Dave, Brisbane Australia

Hello All, I wanted to have a go at configuring MQTT in JMRi 13.7. I have been able to connect to broker.hivemq.com and I have MQTT Dashboard on my phone. I tried to add a turnout to the turnout table

Hi Timothy, While my experience with jmri is very limited (so far), my professional expertise is in the audio realm. It is probably something like the decoder creating an endpoint in the waveform that

123 is the key to the question. If you get "Found mfg 123 (Masoth Electronic, GMBH) version 123; no such decoder defined.", and/or all CVs return a value of 123 and long address 15,227 it is 100%

My version is 4.11.4+R4534304. I checked defaults, and yes it had changed to internal.? I reset to NCE as you suggested.? Now working perfectly.? THANKS to Peter and Tom.? I will get the upcoming

Hey Timothy, It may indeed be something else, something like you hypothesized... but, it might be the nature of the waveform on either side of the zero crossing. ?For example, if the signal is

I'd say start by confirming the node configuration is showing the right type and bits of the I/O cards on the SUSIC. Next confirm you have the right turnout names for those cards. So the turnouts

-receiving inputs from sensors- blocks indicate occupied correctly on layout panel -can't get turnouts to operate - turnout simulation works on panel - cmri hardware is one Susic node with one output

Sorry Peter, I had actually thought I had posted it on the NCE Board. But will do. Thank Dave Sent from my iPhone 6 Plus

Hello all,? I have had much success with the virtual sound decoder except in one area.? I have created my own decoder config and sound files and am having issues with the Looped throttle notch

Go to your preferences and check your defaults tab, most likely have changed to internal. Change back to NCE. The update JMRI to 4.14 when it is released, hopefully in the next day or two. -- Peter

Norman, What version of Jmri? Your symptom points to Preferences - Defaults being set to Internal. Jmri 4.10 had a problem automatically doing this and not telling you. It continued into 4.12. I

Not JMRI related and should be moved to a more appropriate forum. -- Peter Ulvestad JMRI Users Group Moderator - http://www.jmri.org ( http://www.jmri.org ) Tam Valley Group Moderator -

I need help with accessing the programming track, which previously worked perfectly, but no longer.? For some reason the program will no longer correctly read values for the CVs when the loco is on

How about a photo in the files section, let us know how to get to it. John