开云体育

Which transit is that running? I am getting confused, I thought the problem was with FALMOUTH_BAY (? I'm not near the layout panel at the moment). Steve G.

Thanks Nigel Gives me something to think about. Steve

For this question let's keep it simple: 1) One car type, Boxcars 2) The length of the lumber yard track would be 180 feet. The sawmill track would be similar at 200 feet. One train a day would pass

I ran a simulation off line. I started PanelPro and loaded the CCRR profile. I cleared the offline hardware detectors with script?InitUnkownSensors. I put the system into ABS mode with PB on

Yes, but you need to decide on method, there are lots to choose from, and lots of pros/cons. In no particular order: Transponding (Digitrax and maybe one or two other makers) RailCom (mostly

Can JMRI identify where an engine is on layout panel and if so what is required to do this? Just looking for some short guidance in general what equipment is needed. That will determine if I pursue

Thanks Bob, your help and knowledge is really appreciated. I'll now move on to the next step. Just for interest, the project involves a stepper motor driving ?a 2 track into 5 track traverser. The

Many thanks for your thorough explanation Leo…..much appreciated. I’m off to play with your system. ???

I'm going to "sort of" combine Peter's and Mick's answers, and add a question for you: You will need a PR3 or a PR4 or one of the newer Digitrax command stations to download a sound file to a

It's bad form to cross post across multiple forums. -- Peter Ulvestad JMRI Users Group Moderator ( https://www.jmri.org ) Tam Valley Group Moderator ( https://tamvalleydepot.com/ ) Sprog-DCC Group

Double posted. I'm just now exploring ESU programmer. It of course wants to be hooked up to my programming track to function,So does JMRI. My question is can the ESU programmer, JMRI and the Power Pro

Yes. When I copy, paste and edited that script, I left a “self.” in that shouldn’t have been. Change line 11 to port = portID.open("JMRI",50) (i.e. remove the “self.”). In general, if

Great! Thanks a lot. Will give it a try. best, Federico Carminati av Ste Cécile 29 1217 Meyrin Switzerland/Suisse Tel: +41797732246 ?

Does this help NameError: name 'self' is not defined in <script> at line number 11

Federico, You could use LogixNG to restart JMRI. Dave Sand

Thanks Leo, I'm looking for that sort of flexibility that warrants seem to offer. When you say "if the signal is not defined in the OBlocks table, then the warrant will not see it" is that the same

Yep, that works. Thanks a lot. The only thing lost is the autorestart option, but I guess that with a script one could recover even that behavior. Thanks a lot again. Best, Federico Carminati av

I speed matched about a dozen engines following this method: (NOTE all changes to decoders are done on the mainline, NOT programming track, because you can run and make changes at the same time) 0-

That's one of the major reason a car can't be moved, if there isn't a track willing to accept the car, the car doesn't move.? But maybe the reason is that the train length was exceeded, maybe it was

Is there anything in the log? You reach that via Help -> System Console. Bob — Bob Jacobsen rgj1927@...