开云体育

I notice you omitted the word "technical" which has previously been a part of this notice. Please explain. Regards

Hi Dave and everyone, Thank you all?for your help on the subject.? Kind regards?Duncan

It's been half mentioned but just to reinforce it - if a short turnout is its own block, then you will need a LOT of resistor wheelsets at regular intervals, or as soon as the turnout block goes

MFRC522, Ethernet/Serial, Nano/Uno/Mega Steve, OK, so I tested this latest version using a Mega and 1 reader, with no shield since I don't have one at home right now to use. Uploaded sketch, open

Mel, Once again, the .txt files are both for the manifest of the Mina Turn,?one built on 4/30 at 20:32 And one built on 4/30 at 21:06 So, still lacking the details from the build report, let's at

Dave, thanks. Now I understand.? I'm using MQTT signal masts -- Douwe

Duncan, For a Power Pro system with Number of Recalls set to 6, the Show Cabs display would be up to round 384 rows and take a long time to display/refresh. For a Power Cab rhe table would be much

Hey John, Why not just create a new location named "Lakeview Team Spur"?? Then you can name the spurs found there after each industry you want represented.? This will have a side effect of the Team

Duncan, Each row you see in the Show Cabs is the partial contents of the Cab Context Page for each Cab Bus Address. This part of command station memory also has a ";swap area for RECALL key" memory

Dan's correct. Use the pooling feature. later Inspector Dave Onalaska WI

Duncan, Remember that cabs in that context means other throttles, AIU, or similar things on the cab bus. It does not mean locos. -Ken Cameron, Member JMRI Dev

On Mon, May 1, 2023 at 05:58 PM, <stephenjohnson500@...> wrote: > > MFRC522, Nano/Uno/Mega, Serial/Ethernet > > Tom, > > I tried this latest version of the sketch on two combinations. The

Where do I find this momentary action setting?

MFRC522, Nano/Uno/Mega, Serial/Ethernet Tom, I tried this latest version of the sketch on two combinations. The first was an Uno and single reader being used in Serial mode. Unfortunately it didn't

Use one of the spdt switches of the Tortoise motor to switch the frog polarity. The single wire dropping from the bottom of the point is the wire to power the frog.

May I suggest one resistive axle per truck, and that one on the 'outside' or closest to its end of the car instead of every axle? That wire you mention is to power the frog and can be powered by the

Thanks, Yes I know what resistive wheelsets are.? I'm planning to use them on my rolling stock (one for each car axle). I believe the resistive wheelsets draw current and that allows the Digitrax

We would like to point out that this list is for discussions related to JMRI, and is intended to be a place that people, particularly beginners, can turn to for help with their JMRI problems from more

Tim, Also bear in mind that it is very important that if the turnout reports as free, there must be no possibility of trains touching when attempting to pass. This has a huge bearing on where to

Good, that clears everything up, I think. You are clearly hoping that address 3007 is the one to use, and CVs 17 and 18 are set up correctly for that. However! That combination is a LONG address, and