开云体育

Doesn't matter. What you use it for is up to you. -- Peter Ulvestad JMRI Users Group Moderator - https://www.jmri.org ( http://www.jmri.org ) Tam Valley Group Moderator -

I have error messages, which are included in the System Console. 2020-05-13 10:55:41,886 configurexml.ErrorHandler? ? ? ? ? ? ?ERROR - Parse error while parsing file

I think that’s not an entirely correct interpretation. I understood the shared CVs enabled the sound decoder to receive throttle inputs (and others) so it could match engine, cylinders and exhaust

Sometimes it's leftover com port assignments from previous devices. I like to use usbDeview from Nirsoft (free software) to clear them off of Windows machines. I now use Raspberry Pi's for model RR.

Not sure if you mean audio or automatic reverse. I have 3 Digitrax AR1 auto reverse units, that work just fine, set and run. Phil

My problem was that the sound decoder was not working when the motor decoder was. I did not know that both decoders had the same CV s so that I could get the sound on the motor decoder. Thanks for

If you want a really simple approach pick up a AR - 1 audio reverser module.? Let the reversing Loop take care of itself

Having looked at both definition files, I do not see why you would go to the trouble of adding the switch in this specific case. Since the DH165xx are fully compatible with the SFX specs, the SFX04

Ken, thank you for the very helpful discussion. It's given me another reason I'm not interested in having proper CTC on my layout. I doubt I'd ever get it finished, anyway. I'm 76, and have only about

With the old SFX 004 and a motor Decoder in the same machine. it was advisable? to fit a miniature switch and wire? the decoders up to it to be able to turn one off while programing the other one

You still have not clarified what your ultimate goal was ??? Two decoders on one address ?? Both decoders showing in the same Roster entry and not having to open two definition/roster entries to

You might try using the PTB-100 with the older Tsunami decoder and the PR4.? The combination might work, then again it might not. My setup has the PTB-100 as a permanent fixture to my Programming

The write ups on manufacturer web sites are unfortunately not updated as time goes by. Perfect example was the Digitrax PR3/PR4. Windows 10 install had you go thru hoops and ladders to install the

Sorry for the delay. Had several other items to address today. Thanks for the help. The Direct mode alone did not fix the issue. Steve suggested I take off the PRB-100. The two suggestions

Sorry for the delay. Had several other items to address today. Thanks for the help. The Direct mode alone did not fix the issue. Your suggestion of taking off the PRB-100 was also needed. The

I dont know what sprog and arduino is but i assume its cheaper. For the direction sensors just define a bunch of sensors in your sensor table. Then when you define each ssl signal place a sensor for

Hello Michael, The way I've always understood it C/I (Classification / Interchange) tracks are used to route cars from one train to another to get them to their final destination while yard tracks

Some folks are just not linear. When doing support calls, I usually give the user only one step at a time. Do this, done? do that, done? etc. Some MFGs have better instructions than others. The SPROG

Personally, I think a lot of these problems are self-inflicted. Several years ago, I tried helping someone with their interface device (on a different list) because at the time I had the exact same

Gearge, Thanks for the info. And also a BIG Thank You to all the "developers" involved in the JMRI project. Thanks Dennis Munro Berlin, WI [email protected]> wrote: