开云体育

I got my Tripplet Keyspsn adapter thru Amazon, Bruce with Prime delivery. They work great Dave In PA Sent from iPhone Xs Max

One thing, as a newbie, I'm learning, is that when learning JMRI, I run multiple sessions over and over in minutes to see how actions work, what goes where, how cars flow etc. But in practice, if you

Hi Steve The panel was created with Panel Editor. It seems weird that it is only turnouts with more than two roads that are affected. I have uploaded a copy of the xml file into the files area.? The

My current thinking is to create two of the same location. Each with a different car, Put both locations in the build but only activate the one I want to use for the build. I have not tried this so I

My thanks for your suggestions. My concern with schedules is the repetitive nature unless the schedule is canceled. Jerry Hampton

Roger, One thing to keep in mind about any 'drive on' programming track, some locos move while being programmed! Early ones were the worst, they could move feet if you were doing a complete rewrite of

Inobu, This is wrong, it doesn't work the way you claim. You said: ---- On boot up JMRI is looking to contact the Power Cab Command station but it will not be able to communicate with it until NCE USB

George - i can consistently get the following situation to exhibit the issue: panels->new panel->layout editor options->grid options->show grid in edit mode [turn this off] options->grid options->snap

Thanks, it wasn’t so much the bargain but the speed in which Amazon could get me the cable. Lack of patience, turns out, probably gonna cost me more time. Bruce in Mt. airy MD

Bruce, That's exactly why I recommend spending ~$30 on buying an ESU or RRCirKits supplied genuine FTDI cable rather than buying a "bargain". Dave in Australia

John, That's certainly possible with Program on Main. Dave in Australia

Can you explain what this means please? "penultimate" block Thanks, Ken

No it cannot. The LNWI basically implements a minimal version of the WiThrottle protocol, allowing smartphones to run trains, nothing else. You need a full function computer interface. Some recent

Hi Brian, What type of panel is it? Layout Editor, Panel Editor or Control Panel Editor? If you'll post your panel file somewhere, we can take a look. Also, there have been changes to the client-side

HI, I have a Digitrax LNWI Loconet Wifi Interface and was wondering if JMRI can be connected to program and run through that?

Cable driver help needed! ? so I went out and bought myself a USB to RS 232 serial cable advertised as with FTDI chipset. When I received ?the cable, The specifications sheet does not list FTDIE but

I'm just about to start construction of a new layout and over the christmas period have been constructing a ne panel in panel pro. All seems fine and works ok in panel pro. but when I started

I connected a siding that was isolated from the main line by insulating connectors. I then attached a power connection to that siding and to an Atlas power router. Thus I could select programming

Wasn't there a post in 2018 or later where a fellow connected all his Light-Its in parallel gave them all the same address, programmed the functions all at once, then disconnected them all, then

Wouter, There is no pending melt down as I posted the original thread for Dave to read. After that there's nothing else to be said. If you look at Larry's last comment "Any thoughts of help to