开云体育

Hey guys i am looking at using NCE LIGHT-it decoders for my signals is there a video on how to wire them up and program them I will be using NCE BD20’s for block detection. Thanks Tim

Tim, Not a video but I used this to get me started. http://www.quaker-valley.com/CTC/JMRI_Panel_Tutorial.html Inobu

Hey guys I am looking at building a ctc panel on the computer for my layout what is a good site to get a step by step video on how to go it. thanks Tim

Dave, Do you know that the PCP issue are pointing to is an issue from 2005 boards?? My boards I have are 2017 and everything is WORKING. Even the 2005 board is working. What do you want me to do? You

Dave, You don't have to accept it but I know I saw the same problem that the OP said he had. I went through this procedure and cleared it. I got the components new out of the box and it showed the

Inobu, I know you have tried several different Power Cabs. But you haven't reported whether your PCP has the extra-resistors fix documented at the following link:

Inobu, This has never been found necessary with any other system using the NCE USB. That rings alarm bells to me. With a normal NCE USB setup, the 12V power to the NCE USB and Power Cab is established

Which panel editor? The LayoutEditor panel will allow you to click (on blank part of screen) and drag (a selection rectangle). Then click inside of it and drag to move it.

Bill, Does your current Power Pro have trouble with reading CVs on sound decoders? More recent Power Pro's than mine have a circuitry change that reportedly solves the problem. I have: - An older

That falls in line with what I am saying. It you allow the NCE USB interface to go RED all bets are off. The handshaking will never start. What you do is watch JMRI when launches Panel Pro. Connect

Inobu, The NCE USB consists of two optically-isolated parts, linked by a pair of optocouplers (TX and RX only, no hardware handshaking). 1) The USB part is a SiLabs CP2102 USB-UART chip. Your computer

Group, Something I noticed when constructing my Control Panel using CP editor.? I have the panel finished and it extends over 4 22" panels, in a 2 x 2 arrangement.? I recently purchased a large 55"

Our railroad, the Castle Rock and Pacific, is 2500 sq.ft. on two levels.? It is freelance, point to point - Galveston, TX to Castle Rock, CO.? There is a classification yard in each of the end point

Inobu, Your symptoms indicate that you've probably got one of the sub-spec RS485 driver chips in one or more of your devices, probably the NCE USB and don't have the PCP modification necessary to make

So basically, if you zoom out farther, it permanently changes the size of the viewing area (at least until you re-load the panel), but it doesn't change the viewing area to be large enough to see the

You're not suppose to be able run a loco on the programming track....I've used dcc++ in the past...program on the program track then run on the main track

I also have an Arduino (Mega) DCC++ base station.? I can run a loco on the main track and I can program a loco on the programming track, but I can't run the loco on the programming track.? Does that

Alright, I've done more testing with the program and I have more information. The problem appears to be difficult to replicate because it's very unusual. It only shows the part of the layout that can

Inobu, That's a crass and unwarranted statement. I've satisfactorily used a PR3 on both Mac and Windows and both were easy to set up and use. I've seen no evidence that this is a Mac-specific problem.

Ken, The reading of the signals meaning is partly what was/is known as "route knowledge". Every driver had to be separately qualified for every route before they could be allowed to be in sole control