That falls in line with what I am saying.
It you allow the NCE USB interface to go RED all bets are off. The handshaking will never start.
What you do is watch JMRI when launches Panel Pro. Connect the coil cable from the Power Cab to the NCE USB Interface. This starts up the micro processor as the USB portion
starts up. Within that initialization sequence the USB Interface will connect the two sides and you will be good.?
If this happens too far apart the ports are deemed bad by both sides and each side is labeled? bad.
The one piece missed was the connection of the coil cable. This is the on switch (12 volt power) being applied to the USB Interface at the same time the JMRI side is?
trying to establish communication.
I tested this all kinds of ways and I got everything up no problem. I was experiencing the same issue that Larry was with the Raspberry Pi4. Using this procedure
I was able to turn it up everything from scratch.
