开云体育

Jerry, Which is exactly why Production Release 4.16 had serious problems. Not enough real-world users downloaded the late 4.15.x test releases so we were unaware of the problem. The developers don't

Ken, If you check the log carefully: - There are no bad characters flushed except at the very end*. This indicates probably not a baud rate issue. - After 11 minutes of trying, a connection was

Ken I do not normally download test releases such as 4,17.6 Jerry

As per Bruce, The PR4 has been returned to Digitrax as new defective.? Driver, cable, port, all checked out fine. Tried Installing on a Mac Air book, same result. He consulted with Digitrax

On most decoders, you can't do readback if they don't have a working motor connection. And programming on the programming track as well as identifying your decoder _does_ require working readback,

Wow thank you all for the great tips. It seems most cost effective and less time intensive to keep the decoders rather than switching to a common type. I'll give it a try and standardize the existing

Gerardh, Your log shows that you are not getting a working connection to your NCE system. Anytime you get the error message about AA, like: 2019-11-22 09:36:02,908 jmrix.AbstractMRTrafficController

The big thing people need to keep in mind about home routers, most were only intended for 10 or so devices using them. While they can support many more addresses, they can't keep track of the traffic

No, web server is not required. At least not with IOS devices. Web server required for Panels and such as I recall. Marc

I'm able to select lights to toggle front/rear when selecting forward or reverse, so they are at least switching to the correct direction. I'll end up switching out this chip for the Digitrax that I

If engine not working that might be a fault. "Lights are toggling "? what does this mean... Toggling NOT under your control ?? or toggling because you selected the decoder and use a function button

Bob / Jay, I forgot one small piece of info on my router connection. The PC I use is a laptop that connects to my home wifi network. When I use my other router for JMRI, I disconnect the laptops

Hi Chucka, That seems to at least indicate that you can address the decoder. Try programming 'on the main' instead - that gets rid of the whole feedback pulse scenario. It could be a good idea to

The word I got back from Bruce is he is encountering a 306 error. So forget the " JMRI replies that it doesn’t receive an answer from a locomotive on the programming "?? That is just throwing

Hi Marc, thanks for the reply. I can give the LENZ decoder a shot in JMRI to see if there's any difference there. I might try the 1K resistor as you suggest, to see if there's any

Atlas web site document claims decoder would be LE063XF? from LENZ. ? They used either LENZ or NCE decoders. LENZ decders and N-scale are known to be LOW load and that could cause the ACK pulse to

Thanks for the suggestion Doc. I'll see how it works. It might take awhile, but I'll let you know. Dennis?Sent from my Galaxy Tab A

Here's where Wi-Fi throttles through JMRI really shine. Who cares about the function number? Just put the appropriate function labels into the JMRI roster and with a little configuring the Wi-Fi

Dave I have enough engines programmed to run ops sessions so I am going to wait for the new cable. Again I appreciate the patience that has been shown by all as I worked through this. Removing the

I mix Soundtraxx, Digitrax, Lenz, QSI and Loksound decoders (of several versions), they are all speed and momentum matched, with standard functions for front, rear and ditch lights, horn, bell, dim