开云体育

Steve, This album shows the dialog windows that can occur for NX actions. /g/jmriusers/album?id=94433 NX Options.png dialog occurs when re-selecting an existing route. This makes it

Thanks Dave. I was able to change your config to use four simulator connections and get your panel to load. I still get some errors creating sensors, but since your question is regarding turnouts, I

Hi Mike, First, I can guarantee that you do not have 4.16.2, as it does not exist. As to your issue, the four digit number is most likely (unless it starts with at least a zero) a long address. If

Spuds: Good wifi signal: yes. Not much in the wat of interference besides me in the vicinity of the layout. Most times, the phones have line-of-sight to the router. Tried YouTube on one of the phones,

Thank you again Jan for the information. I was not aware of this prior to purchasing and installing the device. If I had, I would have thought about this differently. Maybe there might be a JMRI app

Hi Jan, I did in fact download the most recent one and it is the same thing. When you look at the picture that is uploaded, it looks fine, but when you print a list or see the icons or on one of the

I recently down loaded 4.16.2 and went to Sprog decoder pro 1 placed a ROCO loco and read the decoder type it gave Zemo ,I tried to program the 03 standard readout to a four digit cab number. The

LNWI is not a substitute for Locobuffer plus a computer's wifi and does not work with JMRI. LNWI is a device that interfaces Loconet to wifi by setting up its own wifi network completely independent

Rob: I recall from a few months ago a post about picture orientation and also that the issue was resolved in an update. Do you have the latest JMRI version? Jan

Sam: On my S7 airplane mode kills all transmitters in the phone, including wifi. Are you sure your phone wifis are active (the ripple icon showing several ripples and not greyed out or an empty

Yesterday was a long day of troubleshooting (10 hours).? I first upgraded to 4.12 then on to 4.17.3. After some panel load errors, I removed JMRI and reinstalled 4.12. Finally found the culprit in my

What is the absolute easiest way to run a locomotive automatically, stop at a station and start again. I try but am super confused. I have block detection, the latest version of JMRI. IPad control,

/g/jmriusers/files/190729%20My_JMRI_Railroad%20copy.zip S = Second LocoNet (for signaling, was pursuing this approach prior to LCC)

JMRI supports the LocoNet over TCP protocol, so: - Add a Raspberry Pi running JMRI connected to the LocoBuffer - Configure JMRI on the Raspberry Pi to provide a LocoNet over TCP server on startup -

Rodney, I did have "Allow C/I to C/I moves" set, but that didn't have the desired effect.? I think this is for two reasons: 1) the moves are C/I to/from spurs, and 2) I think this only applies to

Hi Mick, That's true, but that's short pulses. Moveing of at, as described, a slow and steady speed is something else entirely. Wouter

A loco moving on the program track while reading the decoder is normal behaviour. Many decoders use the motor as a load to generate the ack pulse, and so the loco moves.... Mick

Gary Just dive in and create your custom loads. Remember a "load" of "Empty" need to be designated as such. All other loads are just letters and auto to a load by default. Once you unlock the schedule

Thanks, Dave. Jim K

Rich, if I’m not mistaken there is an issue with reliability of Read All Sheets. ?I’ve experienced this issue my self and my work around is a simple one; if a new loco I let JMRI try to find the