开云体育

@ Ken Cameron, Member JMRI Dev Team I have been using SPROG together with JMRI DecoderPro 4.15.6 for some weeks now and find both very helpful. But? - in my way of looking - there is one real

Hi all I am continuing the Signaling Basics series in today's video: ABS, APB, Moving Blocks, and CTC. https://www.youtube.com/watch?v=cWBbyM9iy4E Have a nice day Hans

Hi guys, I run for long time JMRI different versions? ?under Netbeans? IDE? .today for some reason i got this error? ?and? after some time the? process freeze and stop working and output an

Dave from Mount Joy, It wasn't the Kangaroo Juices (we brew good craft beers down under), although I had partaken of a very small number. It was more likely due to my having driven over 400km that

You can also configure the Raspberry Pi to autom

Hi Tom, Thanks for your reply. I will do what you suggested. Many thanks, Warren Sent: Saturday, June 01, 2019 4:13 PM To: [email protected] Subject: Re: [jmriusers] What is the most recent "User's

I want to thank everyone who offered help with this problem. It finally works correctly now. Too much thinking for an old man. Rance ________________________________ Sent: Saturday, June 1, 2019 3:52

OK, clearly the RH turnout decoder is dead. The thing to investigate is why, so the problem doesn’t repeat. Looking at the RH turnout photo, I would be concerned that some of the wires could catch

Sorry for the lack of response. I had a very busy week and I did not get time to check messages or work on the project. First things first, I have some good news to share. And some bad news. 1. I

While I might be tempted to try to duplicate your Ethernet problem... I'm not sure I can... Looking at the coding to configure the connection I see three specific Ethernet shields listed and would

Dan, Have you tried simply loading all 4 'panels' and then saving the result as a 5th 'panels' file with its own name? Normally that is how JMRI works. That will still open all the different panel

If I understand the question properly, the following steps should work: 1) Start JMRI PanelPro cleanly, without automatically loading anything, but with the appropriate connections defined. 2) Load

Hello all: The Arizona Railroad Historical society is building a layout in the Arizona State Capitol Museum. We are learning two technologies...? LCC and JMRI.? To ease the learning curve we split

When an interface changes, as JMRI does from time to time, it’s really interesting how different reactions people have. I certainly don’t know the best way to navigate the line between people

Dave: You are correct of course that the clicking idiosyncracies can be avoided quite simply (and the roster entry method you describe is exactly what I usually do) but the fact remains that

Lee, It looks like all that worked as expected. This I find really interesting, and frustrating. Here’s an example of part of the read sequence: 16:55:41.184: [packet:22 15 08 3F] Service Mode

Hello Ken, No it is not a serial ethernet, but an arduino ethernet shield that comes plugger on the Mega Arduino. It uses the classic ethernet protocol. Thank you :-)

Thinking Dave down under, had to many Kangaroo Juices. Just teasing. Thank for all the help you provide to this forum Dave Mount Joy, PA Sent from my iPhone 6 Plus

Fcot, Are you using some serial to ethernet adapter? If that is the case I suspect your setup for things like how it knows when to send packets is not correct. I've seen a lot of those devices that

Hello boy's Bad news ! Yesterday I mounted a brand new DCC ++ Ethernet for a friend, and the problem of slowness is reproduced. We switched to a USB serial and everything is ok. Thank you Jim