If I understand the question properly, the following steps should work:
1) Start JMRI PanelPro cleanly, without automatically loading anything, but with the appropriate connections defined.
2) Load file A.
3) Load file B.
4) Store as file C.
5) Stop JMRI, then start again using C if you want to.
Each load step take the file contents and creates the corresponding items within JMRI memory. By loading two, you have both sets there. Then, when you store the contents of JMRI to file C, you¡¯re storing all of that.
Bob
On Jun 1, 2019, at 11:53 AM, Daniel Kubarych <danandsharek@...> wrote:
To simplify the question, "Can you take a turnout table, a sensor table, and a block table with associated panels generated in two separate JMRI configs and mash them together to form a third valid configuration". I want two from column A and two from column B to make JMRI configuration C.
--
Bob Jacobsen
rgj1927@...
Bob Jacobsen