开云体育

Six minutes sounds very long. What’s the status line showing while that’s happening? Is it retrying a read multiple times? What programming mode are you using? Bob -- Bob Jacobsen

What decoder were you trying to read? Does th loco have a keep alive in it? These at best interfere and at worst, prevent reading of or writing to decoders. One can desolder one keep alive lead, use a

Hello @ all, In recent days the time to identify a locomotive with Decoder Pro has become extremely long. About 6 minutes.?Before that was going much faster. I came back to an earlier version of

@Jim Exler, What you are saying makes sense to me. The picture I referred to was no the same orientation as mine and I guess I didn't do it right. I am still very new to this hobby and electronics in

In PanelPro, the logs should be visible under any Help menu as "System Console" Can you please create an issue at https://github.com/JMRI/JMRI/issues/new and attach a backup of your Operations data to

Great Paul, I'm busy today but will try to have a look at this tonight. Thanks Lee

Hi Dave Thanks very, very much for doing that. Yes it works fine now on what I have tried so far. I see you are using the LRoute and routes to initialise the sensors and turnouts now. I was running a

Rizwan, First let me state, I have never seen one of these turnouts and don't have one to play with; I can only go by your picture. We will be referring to the picture of the bottom with the soldered

Evening, I am running 4.15.6 on one laptop and viewing various functions on a tablet attached to the layout. This evening, I attempted to load up the cars table to inventory and received the following

Jan, Sorry, forgot that. Yes. Correct. Dave in Australia

PS: Forgot to mention - duplicating roster entries works flawlessly now.

Thanks Dave. That did it. All sorted now. There was indeed a "roster" in the path for the Roster location which obviously resulted in creating the nesting when I was setting things up long ago. The

It sounds like you don’t have a printer attached to your RPi. It might be easier to run another copy of JMRI on another computer and print the roster from there; you just have to move (or file

Rizwan, You can't set the address of your DS51K1 in Programmer mode. You must be in Command Station mode with power on. That's not a problem. The majority of stationary decoders don't suppor

Jan, Sharing via Dropbox is fine, lots of us do it: <http://jmri.org/help/en/html/setup/Dropbox.shtml> The Roster Location needs to be at the level above (i.e. containing) the "roster" folder. I'd say

I have been using it since you posted it on https://github.com/JMRI/JMRI/issues. I now can Identify a decoder?on the programming track?that is on the roster. I now can read a decoder and add it to

Rizwan, In looking at the pictures again I find that the photo of the turnout from the top with the yellow wire is in the straight position but the photo of the wiring on the bottom, the turnout has

interesting - - -a NCE accessory for example, can be configured to look like a loco to the network bus when tied to the rails. As well as an accessory decoder ( when on the throttle bus) The

Thanks for more replies guys. Jim Exler, Thanks for looking at the wiring and identifying a problem. I changed the yellow wire to connect to the outside rail of the straight track (with the turnout

There appear to be some issues with printing. When printing a roster, it appears to make a postscript file (ps) In another case, printing of the roster (to file) creates a pm file...something to do