开云体育

@Bob. I don't use a Digitrax system in between. I have connected the DS51K1 directly onto the turnout itself (as per

The word Arles should be tables Also I opened a second loconet connection in preferences and then erased it going back to just the original connection. Tony

Ps: its panel pro 4.14 Tony

i started a new profile. Digitrax simulation. APPLE MAC BOOK PRO i open tools/tables/ turnouts i enter IT1 , LT1 ?I CLOSE THE WINDOW i open the window, everything is there. ?I close panel pro. i

Rizwan, Although I don’t have a Pi-SProg or the accessory decoder in question, I think I know the procedure. It may work and it may not but it might be worth a try. The following assumes that JMRI

Folks, As of JMRI vers 4.15.5, more flexibility has been added to the MQTT topic with more flexibility to come and the payload can have a JSON string or plain text. So the direction we are going is

Have you read down thru here - - - http://www.jmri.org/help/en/html/hardware/loconet/Digitrax.shtml I personallyy run NCE. Also do a google search for your decoder and see what is discussed. so - with

Rizwan, All DCC decoders will have a default address when shipped. NMRA Standard S9.2.2 says that a bare unfitted loco decoder should have short address 3 as the default when sold. But that doesn't

@Jay, Thanks for trying to help. I have read the Turnouts documentation. As I've mentioned, I've tried to "Add Turnouts" or directly control it using "Turnout Control" with the? Yellow wire connected

I struggled with this on a raspberry pi. I think the roster peport is a .png file which is a postscript file. The printed report is not very flexible at all,,,i believe. I use a screen capture on the

Fraser, I only use Full Interlocking. As far as I know, Turnouts and Signals is like full interlocking without the block allocation. I have not had any issues with signaling when a route has been

Hi Peter, he was asking how to input the switches into JMRI. He said he tried but could not get them to "stick". I felt that was a good start for him. Jay

Hi I have been looking at setting up NX routes on my Layout Editor panel and see that there are three options:Turnouts only, Turnouts & Signal Masts and Full Interlock. Turnouts only I quite

Can the list be exported as a CSV file? You can then import it into Excel and format how you want before printing. Sent: 26 May 2019 21:24 To: [email protected] Subject: Re: [jmriusers] Locomotive

Rizwan, - Turnouts have their own separate DCC address range (1-2044). - Signals have their own separate DCC address range (1-2044). - Loco short addresses are a separate DCC address range (1-127). -

Those have nothing to do with programming the decoder -- Peter Ulvestad JMRI Users Group Moderator - http://www.jmri.org ( http://www.jmri.org ) Tam Valley Group Moderator - http://tamvalleydepot.com/

Hi, Here is the JMRI instructions. http://www.jmri.org/help/en/html/tools/Turnouts.shtml Jay

Thanks Morgan, You are right, i can take a screen shot. I’d love to see a modification to JMRI where I can get the program to print a list or a summary in the same order as i show and/or save within

A solution I use when all else fails. And it requires Windows 10. Is to use the snipping tool. It will capture only what's on your screen. But you can enlarge the screen to full size and that does

Jay, Thanks for trying to help. 1. Power off - I did have power-off when I tried to add the Yellow wire before. It didn't work. But based on what you are saying, DS51K1 would never have responded to