开云体育

Peter - Thanks for the clarification. ?These posts should all be helpful in better using JMRI. jerry ___________________________________ jerryg2003@...

Jerry, Technical aspects includes how to use JMRI, as such this is the place for beginners to ask for assistance. Topics can stray into hardware on the layout used through JMRI ( such as signals ) but

That's the right place to look, but you don't have DEBUG turned on for dispatcher, or you'd see many more messages. To enable debug for Dispatcher, add the following line: to your default.lcf file and

Richard, thank you for your reply. I have indeed been trying the demonstration version of TrainController Gold. The purpose of the exercise is to determine which is likely to be more suitable. The 15

Thank you for your responses. As to the debug for the dispatcher, do you mean the console output? If so, the output with a single train running is as follows: [code] 2018-08-14 16:09:05,891

Steve, thanks, In my case the stop signal was set well in advance of allocations for the on-coming train. I noticed that at the end of the allocated sections there is always a stop signal. How does

Thank you Nigel.? I shall delve into this one.?? Cheers Graham

Thanks Bob

Suggested reading http://jmri.org/help/en/html/hardware/jmriclient/index.shtml http://jmri.org/help/en/html/hardware/loconet/LocoNetServer.shtml The former is general purpose and might be what you

The tool for scanning the cab bus is on the NCE menu, Show Cabs. So most people with a Power-Pro system use addresses like 50 and higher for the AIU address. Each board or throttle must have a

That's likely because the USB chip in the cable probably is a counterfeit version(from China) of the Prolific 23XX family. The new drivers forced with a win10 update won't work with the counterfeit.

AIU is set default not enable. I solve the problem but further testing will go on. The Belkin Serial to USB that I have been using for serval years does not like Window's 10. I switch out the cable

Here’s the AIU manual from NCE. Notice it does not suggest using low numbers. The table starts at 4 and goes up, zero is not shown. I have five starting at #50 and have no problems. Don Perla

Hi all, Is there any way of using two computers on JMRI ?? There is such a lot going on in my layout including Dispatcher.? The sensors and TowerController are run off the Loconet bus.? The trains

There is a function within JMRI which will list all devices on the Cab Buss, not sure where it is though. With your AIU set to "0", that may cause a problem. From NCE "Information Station" PH Pro /

Will this image work with the Pi-Sprog?

Hello James, I am struggling with similar issues and have been pouring through many, many lines of code to learn how JMRI can truly automate train movements. So far, I also keep running into

EPROM version is set for 2006 and later AIU is set to 0 Baud rate is set to 9600 in Power Pro and JMRI Com Port is on 6 I use a Belkin Serial to USB Model F5U409. I have had it ever since I started

panelheight and panelwidth are the size of the underlying panel itself. When it opens, windowheight and windowwidth are how big a window to display. (If that’s enough smaller, scrollbars are used)

George, From my view, the bigger use for a document would be as an overview or guide to JMRI. It would try to document the concepts and thoughts behind JMRI and how to figure out which parts you want