开云体育

Mike I have a Sprog II and a Sprog 3 and use a 15 volt supply for both. No problems with any decoder. Gerry -- Gerry Hopkins MMR #177 FNMRA Great Northern Downunder

George, It doesn't matter if anyone agrees. If there is no one willing to put in the work it won't happen. I personally think the effort would be better spent elsewhere. -- Peter Ulvestad JMRI Users

A simple fix that comes to mind is that the Local starts at the storage track with a route of Storage Track - Barge - Industries and then return. Set the moves in the route for Barge at 0 for set outs

For those of you who have been following this thread, some private communications with Peter Akers has resolved the issue. Turns out the "Selective Lead Loco Sound" preference does not mean that F1 &

Thanks! Will work on it very soon. I did order a new cable as suggested. Will know by Thursday. Ron B

Yes, but I for one like to have something in my hand to read. A real printed manual at my leisure instead of staring at a computer monitor. I can also concentrate on learning about the program

An extra step for High Sierra and later: In High Sierra, you must open System Preferences->Privacy and Security and allow the kernel extensions (drivers) you installed to be loaded, or they will not

Mike, Using the PR3 as a standalone programmer, what power supply are you using? I use a 19 volt supply, other use 18 with no issues. Similarly, what power supply with your sprog (which is probably

Using your Pro Cab, under SETUP COMMAND STATION: - Check the EPROM version and report back. - Ensure AIU broadcasts are enabled. - Make sure baud rate is set to 9600 (in the Power Pro). Make sure the

I suspected as much. I will enquire of Digitrax as to if and when they might update their Loconet Personal Edition. Doug Soeder Sent: August 12, 2018 20:21 To: [email protected] Subject: Re:

James is correct. You do not have the correct drivers installed for your Trendnet TU-S9 RS232 to USB. The SiLabs drivers are for the NCE USB board, which is not suitable for the Power Pro. You need

Two things might be happening, both need looking at: a) The “defaults” in the preferences might not be set to the Sprog device b) It would appear that a “profile” may be the cause of not

Andrew, Turn off direct control. It uses the left and right buttons to change the direction. Dave Sand

Frank, For small changes, you can use TextEdit. Dave Sand

Hi i have built my layout in layout editor with all turnouts assigned. I have the options for layout control, direct turnout control and hide Unselected leg set. My turnouts operate just fine when I

I have a small layout but I have set up a somewhat complex process. Cars are in my storage boxes off the layout. they come on the layout up to 10 at a time on a car float/barge The local picks up the

I think you will be happy with the sprog 3. David

I am converting from a PC (Windows 10) to a new IMac computer. ?I have everything running now as I want with the exception of scripts. ?I need to change a script. ?I have changed a script (example

Thanks for the suggestions all. I think from reading the various replies I’ll have to bite the bullet ( or whatever the train analogy is) and buy the Sprog 3 with the 2.5 amp output. I inherited the

Yes, I see them. Regards, Daniel Dawdy - The Model Railroad Resource LLC 407 East Chippewa St - Dwight, IL 60420 Voice 815.584.1577 / FAX 800.783.0127