开云体育

JMRI is querying for the status of devices connecting to the LocoNet. But for some reason, perhaps because layout power is off, the command station is rejecting the requests (that’s the “Switch

If I have JMRI running on my computer and then plug it into my Digitrax command station this comes across the loconet monitor screen (just a sample of the full trace) Interrogate LocoNet

Hi Paul, ?? I mentioned in an earlier message that I hadn't been able to recover a largely working layout from a number of changes and updates etc., most of which were relatively minor, however it

I recall someplace (so usefull I know) a toggle to put a delay between throwing turnouts. It sounds like this could be enabled. [email protected]> wrote:

Assuming that the engines always run together. Set both to run headlights based on consist address. Set both to never turn reverse headlight on. If you're worrying about horns/bells, etc

Hi Dave All these items you have come up with were caused I think by me following the suggestion in the Check menu as mentioned previously. I think I will have a look through my backup files and find

Option Reset previous Aspect does not affect the result. When I switch the turnouts from the Turnout Table, there is no delays. *07:05:05.726* : [packet: 52 1A 88 C0]? Accessory Decoder Operations

Manos, Ok, here is a few quick clues. First if you do a save in the tables, it creates a file that is same as if you did Panels->Save Panel, but the tables only saves the table items. I always use

Hi Ken, I did save the parameters but could not find a way to reload from the same menu (tools->tables->turnouts). Reloading was my first thought but I guess this happens from the startup of the

Thank you for so much careful testing! Much appreciated. Let me know if you find any untranslated pieces, please. Bob

Manos, After you name the turnouts, did you save the panel file? Then you'd have to set the 'Startup' to load that file. That should make the user names hang around. -Ken Cameron, Member JMRI Dev

Is anyone working on modifying the Slot Monitor to be able to read the non-Standard slots that are available on the Digitrax DCS240? Doug Soeder

We would like to point out that this list is for discussion of the TECHNICAL aspects of JMRI, and is intended to be a place that people, particularly beginners, can turn to for help with their

Hi all I have a small N scale basic layout with US locos and trying to find my way in JMRI. When I define turnouts everything works as expected but one thing. The "user name" of the turnouts vanishes

Tom: Off topic except for zen and repairs... My 10 yo BMW station wagon had both rear window "regulators" die the same day... pop door covering off... easy pull regulator out pie of cake... after

Hi Bob I downloaded and tested built #2618 and it looks fine. Here are a few test I've made *Using DP and PP with preferences already set to English* *1) Lauching Panel pro using the Profile

Thanks for your time, Paul. Please note that I have the timeout error also if I write CVs with the "Simple programmer" in POM mode, so I don't think this issue is relate to a specific decoder

Benny, The “setSingleSegmentRoute" method was added to support new Logix actions. You “might” be able to get it to work by simulating the NX sensor button clicks. Since there are a lot of

Is it possible that when in POM write mode the Z21 is not actually responding to JMRI at all, but just doing the write as requested, no acknowledgement. That would trigger a 306, would it

Also, do you have the program starting directly into your desired profile, or do you have it show the profile selector box at start up? I suspect, but haven’t been able to track down, that the