开云体育

Bill, JMRI is probably hanging up because it's trying to connect but can't. I'd suggest setting up a profile (or modifying an existing profile, if you have one) with one of the simulators selected as

Billybob, Yes, that makes a lot of sense! I was checking out all the signal head types in JMRI and "Quad" seemed to be a type that would work, but it had four spots in which to enter turnout addresses

Thank you Peter, once I got over the system name not being what I expected it to be, I was able to get to work. Larry

When I open a new throttle, I see grayed out buttons F1 - F15. When I select a locomotive and click <Set>, however, all those buttons turn into SS1 - SS16. Also, when I look at the function map, I

Reference: JMRI Ops ?I am a new user of JMRI Operations, trying to use itin simple form for operations only, with no interface to my HO railroad. I havebeen working on implementation for two months

Equivalent for Android? Nope, better. Engine Driver (a most excellent app with superior support) is what I use. It connects to WiThrottle on JMRI, and as mentioned above, DigiTrains is available as

Does your WiFi interface have an ip address when the computer isn't connected to the network? Does your computer run dhcp for the phones that will be trying to connect?

You could also try DigiTrains (by Gyori Belazs) which also works on Android and talks to JMRI. I have both DigiTrains and Engine Driver on my phone, so I can use whichever I feel like. Ian Morgan

I've seen close lightning strikes (tree outside the building) where the induced voltage in internal-only cabling has been sufficient to destroy (blow the tops off) chips (including opto-isolator

Several years ago we had a power surge due to a nearby lightning strike. It burned up the compressor motor to the heat pump. Didn't damage any Digitrax equipment but fried some chips in C/MR-I. I

Well probably the cheapest solution then is to disconnect the Loconet cable (6 conductor flat wire) at the entry / exit from each of the metal boxes. Easy to do but a pain. That way if there is a

I have a Lenz based system using signal mast logic and full occupancy detection using Lenz and LDT kit. I can run dispatcher and autotrains on a simple loop, turnout and signal heads all change and

same solution. Total isolation with fiber optic. I do not know what locket uses for a transmission media. RS485 2 wire, ??? There are isolators for all industrial networks. If nothing can be found for

Those system names ( IH:SE8C:"LT257";"LT258", IH:SE8C:"LT259";"LT260"...) are correct. Peter

I am new to model railroading, and in the beginning stages of setting up an N scale system. I will be using Digitrax products so I will be using the SE8C for signal control. I have finished R.

While the Sound Value decoders have reduced features than a Tsunami, I wouldn't say it has very limited capabilities. They are actually very good decoders. That said, the OP is talking about the DCC

No, he is using Loconet through the piping.

Thank you everyone! I found it!! Jay

Harry,?I have 1 Bachmann soundvalue locomotive, ?a GP40-2, it came with a Tsunami OEM, ?and VERY ?limited capabilities, ?but it does support speed tables.It has pre loaded ?ones, as well as user

The only way to stop this is with total isolation. It sounds like you are using ethernet for the network connections. NEVER EVER leave a structure ( house ) and go to any other structure and run