开云体育

Tim, Can you open up the preferences and then select the "Defaults" panel from the menu on the left. Make sure that everything is set to either the Z21 or Z21XPressNet connection (it shouldn't matter

Once again I tried searching for this one and failed. So please bear with me if this has been asked previously. I want to print the cars at just one location. So I go to that location, and under tools

Here's the help link to staging tracks: http://jmri.sourceforge.net/help/en/package/jmri/jmrit/operations/Operations.shtml#Staging

Geoff, Yes, that is a correct interpretation of the C/MRI protocol. The C/MRI protocol does not have any message formats which deal with only one output, or only one input. It only has formats which

Dan, Problem solved, but I am confused. Turns out the track had more cars than the route was set for. Same with the other missing tracks. I mistakenly thought that the program would use however many

Dan, Well, my idea of deleting one of the missing tracks and then copying a good track to that track name did not work. I deleted track 2 which was one of the missing tracks. I copied track 1, which

Dan, Okay, I will go try that. Norman

Hi Bob, Although everything with JMRI-CMRI interface is working fine, I have one more question. I have been examining the messages sent using the CMRI Serial monitor. It appears to me that when one

I have 4.2.1. JMRI and am having problems programming CVs 200-500. I have a PowerPro system (not a Power Cab). How do I get these higher CVs programmed. I have the lastest EPROM on my system, which is

Normand, The train build report will show you all 50 tracks and why the 7 weren't available. It doesn't matter which staging track you choose. My guess is that you either have too many cars for the

Norman, The train build report will show you all of the tracks available and not available from staging. Just try to build the train, and press "Cancel" for the staging track selection. The build will

Hello all, Dave, thank you for your reply. I installed the SiLabs CP210x drivers without issue some time ago and, I have no issue with the USB Interface communicating since I can use the Withrottle

Steve, FYI on my Android 7.1.2 device there is no "smart network switch" setting under the "Advanced Wi-Fi" menu. My solution to the problem is to enable Airplane Mode to turn off the cellular

2017-06-21 16:14:09,279 util.Log4JUtil INFO - * JMRI log ** [main] 2017-06-21 16:14:10,260 util.Log4JUtil INFO - This log is appended to file:

Maybe a double post. I see it an Lenz system. Of sourse use an zenz throttle to test with. Which Lenz system is it? See http://jmri.org/help/en/html/hardware/XPressNet/index.shtml

So you were able to rad CV8 with an NCE throttle, correct? Give us the system console. It under "help" on the JMRI start screen, on the bottom is "copy to clipboard". Do that and paste it into your

After attempting everything I could check & verify that things are supposedly in order; I still am getting this error message when I try to identify any of my 12 different locos. According to the Lenz

Mick, You are correct. I was thinking of "Idle" status, but for some reason my keyboard typed "Stop". In "Idle" status, track power is ON but control of mobile decoders is disabled. Thus, lights and

Wow reloading it totally worked, here I was scratching my head not able to figure it out, thank you!

Can you be more specific as to it's specs and the Dell model? Not only could we then tell you if it will run, if you want or need to upgrade it I could point you at the parts that will work for you.