开云体育

I've kept the DebounceSensor script around for cases where you need to debounce sensors but still have access to the 'raw' status. Tumble down and direction sensing logic has some tricks (google

Martin, The reason the Linux directory for user stuff is a 'dot' directory is that is standard for Linux on where you place the 'application settings'. I would suggest setting up a test track

The SB5 is a.different animal. It does read.the AIU . I haven't read any thing in the mini panel documents that would prevent it reporting multiple sensors back to JMRI. It is worth an experiment

Steve, I've tried the test version of ED2.9. The clock on the title bar does the job nicely. The error message was /Warning: No response from Withrottle server for 10 seconds. Verify

Hi Tech Suppert Trying to upload a bug request relating to undeleted Signal Mast Logic but my e-mail address appears invalid - but is not. What procedure to use now? Regards Doug in

Power Cab V1.28 does not support AIU commands. Power Cab V1.65 does. The SB5 uses V1.65 firmware. Mini Panel is not suitable for multiple block detection. AIU is the correct device to use. You need

Doug, There is a sensor debounce facility now built into JMRI, in the sensor table, there is a tick button at the bottom of the screen label "Show Sensor Debounce Information", once that is selected

Hi Dick Try the below link. Do a search on Stringline diagrams. Stringline diagram 2 is the latest one. Skip http://groups.yahoo.com/group/Ry-ops-industrialSIG/files/ _____

In

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the jmriusers group. File :

OK, now I get it. Thanks. Ken

Ken: I'm still working on the panels. They work after a fashion. I was doing some searches on "no neighbor error, because that and delay timer errors are pouring into the logs. I came across a

I have seen posted on this list reference to XL files for a string-line diagram. Can somebody direct me to those files? Thanks, Dick Roberts

Yes you will need to install the correct mac drivers for your USB to serial device. Then you will need to go into the preferences file in JMRI and select the proper connection for the new

You may need to install a driver for your serial adapter on your new Mac. Walk Sacred, David Copson inyostudio.com Sent from my iPhone. Anything that doesn't make sense has been autocorrected.

Wait..You are trying to troubleshoot electronic devices with out a meter??? Come on now!!!! Sent from me. jmriusers@...> wrote:

Martin, I would turn off the Logix for now while we figure out what is happening. Now for each block is there a single feed wire going through the BD20 that then goes to the block. All the

Dave Generally speaking disabling aspects has a bad effect on the signal logic, for example disabling 'Approach Limited' will leave the logic with nothing to display when the next signal is

I've just noticed that there were already existing decoder files for "Bachmann Sound Value" under this family name in the "Throttle-Up (SoundTraxx)" section. Unfortunately these files have the same

Dave: If tou up load you panel file to the ProblemsBeingWorkedOn folder in the files area of the group maybe somebody can look at it and figure out what went wrong. Make sure you crate a folder with