开云体育

If memory serves, EVERYTHING on the cab bus (with a cab ID) shows up. Pretty certain my NCE USB did Phil G

ScottIf you are using a loconet connection is the "Transponding Present" in advanced options set to yes as per item 13 here

Mark, Read this and look at the Tsunami section. It' slightly different from the standard for locking: https://hostlersinn.blogspot.com/2023/04/cv-15-and-16-locking-decoder.html

Hi John & Folks I believe one way to do it is to set up the team track with "phantom" numbers Team Track-1. Team Track-2. Team Track-3, for each industry The Set Out won't be "Ryan's Rebar", it

Hi Duncan, You are confusing loco cabs (the locos under your control) with NCE's concept of a cab, which is a controller connected via the cab bus to the command station, in your case just the power

I have opened issue #11982 in JMRI's source repository to cover this problem.

Then I wonder why all the "Read" buttons on the decoder page are grayed out. My JMRI is 5.3.3 on Windows 10 wiht Java 11.0.14. Anyone have an idea why that might be? Scott Walton

I found out right away that I couldn't think of individual items like blocks, signaling, detection, and power feed. They are all part of a system. Start out with turnout protection. Signals are

Tim, Since you plan to do signaling, I would recommend each turnout, or group of turnouts, has its own block. For example, a "group of turnouts" could be two turnouts acting as a 3-way turnout. Or

The location and size are the most recent values when PanelPro is stopped. If you want to use the "stored" values, go to "Preferences => Display" and enable "Use old location and size logic for

Dear testers, I have just downloaded the current test version of JMRI as you can see by the title. ?I have had a look to see what ‘Cabs’ are on my NCE Powercab handset and can only set the

Scott Using Roco I can read all / read sheet, but, I cannot read any indexed CV. Steve G.

What determines the position and size of windows in jmri? At some point the positions and sizes were recorded. Now no matter how much I reposition and resize windows, saving using "store all tablets

Good morning, I am in the planning stages of my layout. I am currently trying to figure out where I need to place my "blocks". I am using all Digitrax hardware including a Digitrax BXP88 for power

Douwe, The send count option is only applicable to signal mast drivers that talk directly to the layout, such as the "DCC Signal Mast Decoder". Dave Sand

Thanks Tim. My decoders are not locked. I will lock them when I figure it out. Mark.

I followed this discussion and was triggered by the comment that you can set the number of 'send counts' to a mast. I know you can set that for a turnout, but for a mast I haven't been able to find

Since this is a decoder issue and not JMRI you should take your questions to the TCS group. /g/TCS-Users -- Peter Ulvestad JMRI Users Group Moderator ( https://www.jmri.org ) Tam

Good morning Mark, I have 3 TCS WOW-121 Steam Decoders. I think they are very similar. Sometimes hickups can happen on the rails and the decoders can sometimes interpret them as programming commands.

Hello group. I have a question about this decoder. I have 2 GP38's that are consisted together. I have not run these 2 locos for a week or so. --Today when I started to run this consist the locos ran