开云体育

Peter, Now you are getting into the hardware specific actions. My experience is with RR-CirKits TowerMan boards. These are configured so that when the circuit is closed (connected to ground), a sensor

Robin, The only thing you should have to do is set Continuing Route to Thrown. When set to Thrown, Layout Editor reverses the closure segments when drawing the turnout. I have uploaded a very simple

OK....This is what I Find....(after starting Compute)r. ?At the BOTTOM of the window I do the following: A)...I click on System preferences.....B)...then click on Printers and Scanner.....C)...then

Dave, Appreciate the response. I can certainly flip the driven turnout position on the layout and flip the feedback. Not sure how to fix the Turnout Table though. To simplify my remaining question, I

*Update * Photo uploaded into folder MERG - JMRI Test

Hello Fraser, thanks for your reply. *My bench test setup* I have a rather long break from this exercise in combining MERG with JMRI. I decided right from the start NOT to attempt to? incorporate

Robin, The secret is to treat turnout closed/thrown as closed/thrown everywhere except in the continuing route setting and the wiring at the switch machine. If feedback is enabled it needs to wired

Hi Charles, On the Uhlenbrock website, it says: The 74120 Decoder replaces the existing Decoder 76425 with NEM 652 plug. That one happens to be in JMRI, and IntelliDrive2 I added for other models last

Hi. I have a panel with signals set up in Layout Editor and generally everything works fine. The only issue so far is with 2 turnouts where the main line takes the diverging (THROWN) route. On the

Peter Does your MIO have a ULN2803 chip beside the servo connections or an 8-way resnet? If it's a resnet then that probably explains your output reversal. I believe the default is the ULN2803 and

Paul, I have been following this thread and one possible solution might be to set the train build mode to "aggressive mode".? This allows the software to take two (or more) looks at the siding.? It

Yes, that's my experience too. The mac print dialog has a "simple" box which can be "expanded" by clicking a little arrow. The expanded dialog has several scaling options including "fit to sheet".

It is there on my Macs. Click on print and it a box that shows the printer comes up that does not have the scale box on it then click on the show details box. It is not part of the printer drive

NEW INFORMATION...(First, THANKS to ALL who tried to help) I borrowed a friends Apple computer and installed my JMRI files thinking a totally fresh start might help....same result... when I tried to

Dave Thanks for your feedback. I fully agree with you that I should ensure the conditions are correctly set up in MERG and to avoid using JMRI to inverting anything. Spent some time last night

Bob Yes you are right - 3F . Gerry

The problem is that decoder doesn’t do 128 speed steps, so it doesn’t respond when it receives them. As to the comparison: Let me organize these a bit differently to make the comparison easier:

Don Did some testing today here is what I found. LE103 number 2000. Decoder set up - 14SS; CV2=1; CV3=1; CV4=1 * Command Station set up to 14SS as default. * Using JMRI throttle on screen in 28ss mode

Mitch, I have uploaded my two crossover solution. It may have other issues but it works for S01 to S08. /g/jmriusers/files/ProblemsBeingWorkedOn/dsand/Concept%2010%20DS.xml Dave Sand

Thank you Dave, I thought I was going crazy! That all makes total sense, and I’m glad the sensor fix will be in the next update. I’ll backdate to the production release and fix up the sensors side