开云体育

I had a similar problem with an Arduino based servo for turnouts; the servo was only getting a shot of current instead of a significant length of current to move the servo.? You might check how long

I've been working on getting my staging turnouts powered by servos and controlled by JMRI through Arduinos using Geoff Bunza's direct JMRI to Arduino scripts. The ends of the staging yards are far

The give away for whether a chip supports ABC is usually whether you can set cv27 https://dccwiki.com/Automatic_Brake_Control

DP generally only has data from the last decoder read, CV19 is no exception. SO showing the last known value is still good. Opening the throttle with CV19 value (if set) would also make things go

I believe I did explain one way to see the option for the Asymmetric feature, it might be different for another brand of decoders. It depends on who added the decoder information into Decoder Pro. The

Dan The build report says the following for the 3 locations not being picked up 2 were ignored 1 was Cant Send I compared the Car roster with the layout locations and all cars were located per the

Hi Richard, I've not used the DCC++ base station, although I've experimented with using the JMRI interface in conjunction with my own sketch. ?If there's a specialist forum for DCC++ you may get a

Ken S: Do you have JMRI 4.16 installed as suggested earlier in this thread? Automatically defaulting to offline simulator mode when a connection problem occurred was a feature of older JMRI versions.

Steve, I have never needed to change signalspeeds.xml. I tweak speed assignments for turnouts and blocks to get the signal mast logic to work in special cases. For layouts I work with, I set the

What should happen is it shows green thinking there is a connection. Within 10 seconds, it probes the interface to see if it replies right. If that fails, the connection turns red. You should do a

Hello Ken C., I double checked in Device Manager USB Interface using COMM4. When I start JMRI the Decoder Screen at bottom has NCE connected in green message. When I select a loco to program, the

Ken S, The cut/paste of the console log you sent shows JMRI asking for COM4, but the system saying COM4 not found. Insure everything is connected and powered up before starting JMRI. Also follow what

Hello Marc, Here is screen I get. Ken Sent: Tuesday, July 23, 2019 11:11 AM To: [email protected] Subject: Re: [jmriusers] JMRI and NCE Ken, attachements are not permitted and will not come thru.

Thanks Paul, I started this effort by reading the following section on the JMRI site … http://jmri.org/help/en/html/hardware/dccpp/Turnouts.shtml If I understand correctly, I should be able to run

@Dennis Thank's for your explain, but the question only for DecoderPro as you said : "Decoder Pro might give you the answer also if it has the feature for you to activate." Can you explain to me how

Hello, I don't really understand. Did you connect your servo to the same Arduino as DCC++? Did you change the code? Because a servo works very well with an arduino other than the DCC++, the code

This is certainly possible, but It may not be very reliable. You are much more likely to change the consist address than the locomotive primary address, and there are many ways to change CV19 without

Thanks Seth, I thought of this too, but was led to believe that you could run one servo directly connected to the Arduino's 5V supply and there would be enough current. Two or more … yes, a separate

Hi Marc, I did a snip of the screen and I see it is now a jpeg in my Download folder. How do I upload it to the file section? Ken Sent: Tuesday, July 23, 2019 11:11 AM To: [email protected] Subject:

Hello Again, The NCE USB interface is connect through the COMM4 port. When I load DecoderPro following screen appears which I have attached. Prior to getting Windows 10 I had Windows 7 Pro and JMRI