开云体育

You're definitely on old sources… drawPanelGrid has been moved (with the rest of the drawing code) into LayoutEditorComponent.java. Make sure you're working off of the latest development branch.

Hi steve Just seen your reply It doesn't work for me. I wonder what I have done wrong. I have the LH-Xover on my layout, and when dispatcher runs it always sets the points the same no matter what

Hi Mike, If it's just downloaded and not used yet, you'd be a lot better off with the new 4.18 - loads of fixes and support for more decoders. If you did install it, consider updating anyway. There

I should have said 4.16, not 16.4 Mike Shore

I down loaded a few months ago 16.4, I’m going to retry to program my TRIX B-13- EST HO locomotive, later today. Thanks for your help. Mike Shore

Frank, To help understand the resolutions known to JMRI for the attached screens, could you provide a copy of the output from the JMRI context via 'Help > Context...' Amongst other things, this tells

Would setting the car(s) to be delivered three times a year to 'Out of Service' do it??? Then when you do want it to be active, you? can put it back in service.? The Location for the car will stay

cprxmodelrr@...> wrote: That's very likely the issue. Different hardware having different capabilities. In a desktop PC,you could add a dual output graphics card. There may be something similar

Craig, Your first post was dated Dec 8 and its Dec 30 and you are still no where. Get a windows laptop from Goodwill and be done with it. Its not going to kill you to learn another platform. I've

Hi Mike I have 7 Zimo decoders, including 3 sound ones within Roco engines. They are all recognized by JMRI using my ECoS2 Command station, including the latest Roco engine with a Zimo SW release 37

This is be basic break down...... NCE USB Interface combination * Jumper 2 - OFF 3 - OFF 4 - OFF? Reports EEPROM 7.3.0 . Baud Rate 9600?? Power Cab of 1.28 and 1.65 will work. JMRI set to 9600 *

Thanks George, I'll keep an eye out for the fix and try it out. Andy

Hi Steve I am trying to make a panel adapt to user 'capabilities' by controlling the features (such as route setting) available. The 'simplified' panels would be able to be used more easily by first

This would be a great add on to JMRI. I wish I had even a basic concept of programming to make it happen. Perhaps if enough people ask for it someone will take on the challenge.

My PR3? in Standalone mode with power supply : The Green USB led is mostly ON with a? OFF every 2 secs AND the RED ERR is OFF constant. If I disconnect the power supply from the PR3, the red ERR

All my cars are stored either on tracks in a classification yard or stored in virtual tracks in that yard-storage boxes. openning the cars window, select a car and open with set. these is a place that

Hello Again, Still no joy...(yes still on the Mac) I received the new Digitrax PS14 which I have connected to my PR3 the PR3 is connected directly to the programming track. the other end of the leads

Larry, This was a doozy of a problem. I took me a while to figure this one out the sad thing is I've seen this before. The issue is in the initial handshake event. This is the quirk. On boot up JMRI

The simplest way of dealign with the first problem, is using 'zoom to fit', it'll epand the layout panel to fill the window, keepign the same proportions, so it'll stop when hits eitherthe sides or

Hi Dick, Thank you for the reply.? My experience is different.? I can extend the panel created as far as the 2nd monitor's right edge, however there is a large black (my background is black) space