开云体育

It looks like the group does not allow photos. Jay

Rizwan, I am curious as to why you operated the turnout more than once while in program mode. The instructions say to connect the yellow wire, power on, select address, press C or T to operate and

Fraser, I have been testing some of your other routes. Due to your track plan and sensor placement, there is an issue for some routes such as cc07enter -> cc05enter. Because the left fiddle yard has 4

Hi Paul, I'm happy to test I would like to get it working reliably. I can even provide remote access to a machine if doing direct debugging would be easier/quicker Regards Lee

Using point sensors, like IR sensors, can get complicated. You have to consider things like intermittent activation (if the sensor goes ON/OFF/ON as the train goes by), how to handle it if a train

Hi! I would have posted this earlier, I was having issues. Here is a pic of one of my Kato #4 with a DS51 installed. This has been in operation for over 3 years now. Jay

Thanks for more helpful pointers guys. I wish I had better news to share but the decoder wouldn't take an address even with the changed wiring. Jim is still right that my earlier connection was wrong

Hallo, tried to reset ESU Lopi 4 and got that message above. Apparently the values were resetted though. But what does that message mean ? Thanks and regards Joern

Blocks are not directly supported by Logix. You have to use the assigned sensor to represent the block in Logix. Dave Sand

I'll add that the driver was updated in March 2019, so you likely need it. I downloaded and ran the installer. Then when I connected the hardware it went through a couple of cycles (watching the

Hi,? for various reasons I opted to use IR sensors for detecting where my loco(s) is on the track and for block occupancy,? not realising (because i'm new to this) that JMRI seems to only be able to

Doc, First, please say 'which latest' version of JMRI you are using? Second, use the Windows Device Manager to discover which COM port the NCE-USB is using. Do this by having it open as you plug and

Hello @ all! First of all thank you for the interest spent on my problem :-) JMRI is OK! It seems that the problem comes from the shield ethernet, I removed it, passed in serial connection, and in

For months, my ho Club layout has been experiencing difficulties with NCE and JMRI. We have a Power cab with a Sb5 power source and WiThrottle and Apple phones. JMRI shows the phone connection and the

O/S Win10 PanrlPro 4.15.6+Red1ceb2 DCC system Digitrax Zephyr Express for accessory control, Zephyr for Detection, Gaugemaster (MRC) Prodigy 2 for loco control I'm trying to build a logix table for a

Great. Those two things could be related. Unfortunately, there are commands the elite doesn’t send an XpressNet reply to when the XpressNet protocol documentation says it should. We have special

Hi Paul, I tried the new version and it certainly has made a difference. The system will now connect and talk to the controller. I was able to control a train and power on and off the system although

I'm sure it does, Dan.? I came across the issue when I was trying to compare accept/exclude loads and car types for a train.? Any chance you could do a .CSV dump of the data like you've done for

I need some help understanding, using and applying these 2 topics. I am thinking that I & O are yes or Know Jerry Hampton

mike if it did not work try cascaderwy at yahoo dot com matt