开云体育

Ken, I just got it working this morning. ?I removed all the connections except for the one NCE network connection I am using. ?The way it ended up working was to do a complete uninstall, remove the

Paul: David is correct... A command station is that and will not be replaced by a computer running JMRI. I have left two of the (Steve's) RPi-JMRI boxes at friends for their (1) Digitrax RR and (2)

The SUSIC was working and if all up stream from it to the computer remained unchanged you should get the 1 to 1 blink...? I say that not sure if it initializes without it's cards set right... Let's

Bob, Thanks. I should have checked Steve's website earlier. I have not had a chance to read it in detail but it looks like it will do what I am asking. Paul D

Did you change any wiring for the bus? Did you touch the address switch block on the SUSIC? The SUSIC was working ok before. It is now acting like node 0 isn't on the line. -Ken Cameron, Member JMRI

Eric, It seems you have 3 NCE connections, I doubt that is right. I suspect that is confusing the rest of the startup. I would say you need to clean that up first, then see what issues remain. -Ken

Don, The required track segment between two turnouts can have a length as little as zero. You do need to assign a block from one of the turnouts to satisfy block routing calculations. On a friend's

checked dip switch settings .. flipped all of them and reset to 0 for the output board (all switches off), 1 for the first input board (end one flipped), 2 for the second input board (2nd from end

My railroad has several crossovers, in yards so locos can uncouple from their trains, and escape by way of an adjacent track, and one along a double track mainline. Physically, they are two switches

Hi Dave, Yes, it was a Digitrax Sound decoder. They fixed the problem. But I threw that that out as an idea. Sorry if that bothered you. Jay

I am having issues with the new version of JMRI.? I updated both Java and JMRI tonight to 4.14.? I am getting a lot of errors in the system console, not sure where to even start.? is there a way to

That sounds like a decoder brand-specific problem. I have never experienced such problems or heard of it. There are however some issues with the NCE Power Cab (and SB5) firmware that could conceivably

The Raspberry Pi setup is _exactly_ "some option I have to remove my computer from the loop”. It’s a $35 computer that replaces your laptop. You set it up (See Steve’s web pages referenced

Paul, A PC or any other device would not replace the command station. That is necessary for any set up whether it is the DCS240 or an NCE system etc. David Klemm Sent from my iPhone Xs Max

Bob, If the USB question is directed at me, I do not keep my computer at my layout thus it is disconnected from my layout when I turn off my layout and leave it. When? I return, I need to reconnect

Hi Gary, There was an issue, way back that I had, that when BEMF was on, it would cause that issue. Hit horn & the engine would stop and restart the sound process. Not likely anymore, but something

Gary Try YOUTUBE they have lots of videos on Consisting. Search for DCC Consisting, you will find dozens of videos on this subject. To narrow down the search place the brand name of your controller.

Hi Patrick, Before we raise an issue for this, can you tell me a bit more? When I start to build a CPE panel in the current JMRI release 4.14 on?macOS I do not see what your screen shot shows.

Hi Stefan? Thank you for this ,? Andrew

Ken, Thank you. As I received your message, I was away out to celebrate my Polish Christmas Eve with a traditional meal with my daughters and their families. As I am now back in "normal"mode