开云体育

Hi Jon,? Thanks very much.? I've no idea how I missed that.?? Chris

Dick Thanks you for the EXCELLENT reply dated Dec 2nd it has opened my eyes to the differences in the different JMRI design systems. I agree with Alan B Pearce’s comments “ it should be in FAQ”

Hi Paul, Fundamentally JMRI is setup to move a railcar once per session.??A person would?Build all the Trains at once then print out the Manifests and Switchlists for the Trains and Locations (the

Hi Paul, Sorry for talking so long to reply.? Sometimes work gets in the way of trains? :) Looks like you took care of #1. For #2 - yes, if you want the?next train to pick up the cars the previous

Dave Thanks - that fixed the problem. Regards Roger

For what it might be worth, a trick that I have used is to insert a print command into a questionable Logix item. One example snippet, copied from the "Browse" feature of the Logix Table window, looks

Thanks Dave, I get it now. Clay

Clay, The JMRI help system includes summaries of the signal systems. For Basic: http://jmri.org/xml/signals/basic/aspects.xml The generated SML results in ABS signaling. APB signaling can be

Balazs, I usually resort to going to a back rev of the panel or disabling different Logix until find it. I've never found a quick method. -Ken Cameron, Member JMRI Dev Team www.jmri.org

I model the L&N circa 1974, however when I look at all of the signal definitions there isn't one that I recognize for the L&N so I picked Basic Model Signals. From them I'm not sure to choose in the

Balazs, Since you can cause the loop by a couple of panel actions, start by setting any Logix with those panel items disabled. Once the loop no longer occurs, you can enable one Logix at a time and

Hi JMRI experts, I have a panel file where two (or more) logix conditionals somehow ended up triggering each other in an infinite loop. This crashes JMRI (either out of memory or stack overflow).

I've defined all my tracks in JMRI (J), whether I want J to use them or not.? With the new "export locations" feature, it helps me keep an inventory of the tracks on the RR. If I don't want J to use

Yes there are, but you are very unlikely to have one. If a "Read Type from decoder" says "Found mfg 123 (Massoth Electronic, GMBH) version 123; no such decoder defined.", and/or all CVs return a value

Robert, See below: I didn't give you any scripts. I gave you very clear instructions to follow, not scripts. Instead, you did your own thing, made up your own instructions... Good. That wasn't

Ooops...my bad. I was not thinking clearly about spur visits. OpsPro will automatically include all the spurs at City-C thus Train-B will make the stop at City-C and then make a single "move" to leave

Scott....I like it but I have some questions... 1) When Train-B visits City-C, it seem like Train-B must include each City-C spur in the Train-B route to ensure that cars are placed properly in the

Roger, It is possible that the JMRI installer did not remove old versions of some components. Try doing a clean install: Use the Windows Control Panel to remove any JMRI versions. Manually check

Dan and Martin, ... unless the A/D tracks are staging.? I have three westbound passenger trains all departing from the same staging Location, with similar consists and train lengths.? I want to know

Ok Klaus. Thanks. Mario