开云体育

John, That's certainly possible with Program on Main. Dave in Australia

Can you explain what this means please? "penultimate" block Thanks, Ken

No it cannot. The LNWI basically implements a minimal version of the WiThrottle protocol, allowing smartphones to run trains, nothing else. You need a full function computer interface. Some recent

Hi Brian, What type of panel is it? Layout Editor, Panel Editor or Control Panel Editor? If you'll post your panel file somewhere, we can take a look. Also, there have been changes to the client-side

HI, I have a Digitrax LNWI Loconet Wifi Interface and was wondering if JMRI can be connected to program and run through that?

Cable driver help needed! ? so I went out and bought myself a USB to RS 232 serial cable advertised as with FTDI chipset. When I received ?the cable, The specifications sheet does not list FTDIE but

I'm just about to start construction of a new layout and over the christmas period have been constructing a ne panel in panel pro. All seems fine and works ok in panel pro. but when I started

I connected a siding that was isolated from the main line by insulating connectors. I then attached a power connection to that siding and to an Atlas power router. Thus I could select programming

Wasn't there a post in 2018 or later where a fellow connected all his Light-Its in parallel gave them all the same address, programmed the functions all at once, then disconnected them all, then

Wouter, There is no pending melt down as I posted the original thread for Dave to read. After that there's nothing else to be said. If you look at Larry's last comment "Any thoughts of help to

Inobu, Dave, Going to stick my neck out here, with a mention that descending into bickering is not helpful to anyone. Both of you obviously have a lot of knowledge. Dave has a lot more mileage on this

Dave, I don't think you really understand the issue at hand. How can to even clam to test the issue when you don't have a Raspberry Pi 4. That makes no sense what so ever. That is like someone

Inobu, I'm afraid I cannot agree with your reasoning because there are several fundamental errors in your understanding of what communications go on between JMRI/NCE USB/Power Cab during startup of

Dave, Its not called a dance. In data communication it is typically called a protocol hand shake. This process starts with a Service information Octet that starts the communication process between two

Tim, This may answer some of your questions: Light-It with JMRI The Light-It can easily be set to Signal Decoder mode. JMRI provides full support to the decoders, both via Program on Main (the only

Inobu, You have missed one vital troubleshooting step. You haven't reported whether you need to do the same connection dance with a non-RPi4 computer. We've used the NCE-USB to Power Cab combination

Inobu, I don't want you to delete your findings. But I don't accept your conclusions that you need to perform a connection dance with the Cab Bus cable due to some NCE or JMRI timing issue. Your logic

Dave, I think you told the guy to use his Power Pro instead of the Power Cab and get the ESU cable. He dropped using the Power Cab all together. Inobu

Inobu, I believe you've misread something. The FTDI and USB Serial route is not and never has been an option for the Power Cab. Dave in Australia

Hey guys i am looking at using NCE LIGHT-it decoders for my signals is there a video on how to wire them up and program them I will be using NCE BD20’s for block detection. Thanks Tim