开云体育

The way the masts and the speeds are supposed to work is the logic finds the next signal. It then considers the speed (from the mast entry for that signal aspect), the speed limit for any blocks or

Bob: There is a fix... thought I posted link to the Pi Forum page that lead to the link, now I can't quickly find the fix. I'll try to post photo later but I added a heat sink through the top of the

Ken W, It is trying to open COM4 for the NCE connection. Use the Windows Device Manager to confirm which COM port it is using and that the driver is ok. Plugging and unplugging the connection at the

Jim:?? i looked at the Pi 4 a few days ago, there still seems to be some thermal issues with overheating when the CPU gets to a high rate of utilization, it isn't helping that the Pi 4 case has

Hi again Dave, Ken and all Dave: I have tried your suggestion and this really helps to have a better understanding of signal mast logic. The strange routing behaviour issue at cuewait siding is still

Hello Marc, I found the System Console Log. I have attached it below. I now have only one NCE connection now. Ken Skopp Sent: Monday, July 22, 2019 9:18 PM To: [email protected] Subject: Re:

Hi, Are you sure that your servo is compatible with DCC++? A standard RC servo requires a pulse width modulated signal, which the arduino servo library will generate, if that's what you have used in

Is it possible to add a column/field on the roster sheet for a consist address and have DP fill it in if the loco has a consist address. Thanks. Jim K

Bob? Here is an update to the above problem we discussed in Jan 2019. I replaced my new NCE box with the old Wangrow box. I now have control of the UNK OFF ON radio button. Next I will upgrade the

Dennis, You can build your own Asymmetric Stopping block modules for less than $1 per module, using 1N5404 diodes and using this circuit: https://dccwiki.com/Asymmetric_DCC Less difficult than

do you have enough current available??? The servo draws ~ 150mA when it's moving.?? You can turn it off once it's had a chance to stabilize.?? You may want to put the servo on an auxiliary power

Hi Ken, I recommend that you download the drivers for USB interface and reinstall them.???? I have found in the past that whenever Windows 10 installs updates the SILABS drivers have problems and need

to make it easy on the engineers, youmight want to sure jmri is up to 4.16anr go from there

Dan Before I do That I have done some more digging and I have discovered a number of car location problems. I want to clear them and see how it builds. This train has always been an easy build. Jerry

Dave Thank you for your help, and advice. Much appreciated. Gavin

Hi Jerry, What does the build report say about the cars not being picked up.? If the build report isn't too long, you can copy and paste the entire report for us to review for you. Dan

Brake on DC is very crude compared to Assymetric DCC. With Assymetric loco sounds still operate, and react with the changing speed of the engine as it slows and then accelerates. With brake on DC no

Group: Using Steve's RPi-JMRI distro for many months now on a couple of layouts killing power has not caused problems. A possible warning is if the Pi is doing other things too, not just being Steve's

I never had that problem with Brake on DC between blocks, or never noticed that. My blocks where very long. BTW: will have a Asymmetric Stopping block module soon with 4 stopping block outputs, also

I am building a train with nine locations. In 3 of the locations the build does not pick up the car currently located at the location. Therefore in those locations it places cars picked up from other