开云体育

The original panel just uses up a non-ending amount of CPU, so the initial impression was that the logix were locked up in an infinite loop. But that was not the case for this panel. The uploaded file

It was me, not Paul. File uploaded

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* Bondale 4.xml *Uploaded By:* SwissChris

Hi Paul If you load your latest broken panel to the files area, pfoblems being worked on, we can take a look at it. Steve G. -- Sent from my Android device with K-9 Mail. Please excuse my brevity.

Paul, Thanks for pointing out the scale issue. The Dispatcher stored the British scales as UK-? but referred to them using UK_? I did not catch that when I defined the standard scale list. Dave Sand

And for my JMRI problems?

I can imagine that using two turnouts back to back would be easier to visualise than a slip as the "motor", what ever it is, is in the logical position relative to the turnout whereas in a slip the

Chris,? For your Digitrax questions, suggest you go to the Digitrax forum in groups.io. Paul D

You obviously don't have a driver installed for the NCE USB. Please read the instructions below: (Also please update to V4.14 as soon as it becomes available.) Dave Port Troubleshooting Instructions

Having tried using JMRI over the past few months, I have these comments to make: I have re-written my layout every 2 weeks as when I've completed the main layout, it either crashes or locks up. I

Dave, The UP and DOWN Double Crossings are made up using 4 PECO Finescale Turnouts, a Diamond Crossing and short lengths of flexitrack to facilitate movements from UP Main to UP Relief and from UP

Log files in Problemsbeingworkedon/ Mik Moignard DCS240 JMRI 4.13.6 and Indexed Cvs

Dave: I think I used write Full sheet and write changes on sheet on the CV pane because I'm aware of this issue, and it still borked on me.? I also noted that while I had JMRI working in Direct Byte

This appeared to be fine until I ran an autotrain in dispatcher, when I got multiple null pointer exceptions. ?The train failed to run as normal and stop at the end. ?Fortunately I was aware of the

I just downloaded version 4.12 to my Mac? Book. I started to set it up and under "connections" I entered the info requested. When I got to the "serial" choice the only choices were either "bluetooth"

Slot monitor in JMRI 4.13.6 is much better – seems to be mostly back to how I remember things of old. Works nicely on a Zephyr DCS50. Users of systems with more slots, such as a Chief, will have to

There's a known issue with the possibility of "Programmer in Use" if you Write All Sheets on any pane rather than Write Full Sheet on the CVs pane. This has been around for along time and is not yet

Hi Dave and Iain, thanks both for this, been having a fantastic exchange of info with Iain and look forward to making these changes as well. regards Doug

Iain, Interesting comment on slips. I find it easier to use slips. One time I created a slip ladder (3 slips) using slips, signal masts and signal mast logic. Dave Sand

Stefan, To display the graph, you need to select a station segment. The button bar at the bottom will then display the Graph button. For more details, see the help document at Help >> Window Help or :