开云体育

Yes there are, but you are very unlikely to have one. If a "Read Type from decoder" says "Found mfg 123 (Massoth Electronic, GMBH) version 123; no such decoder defined.", and/or all CVs return a value

Robert, See below: I didn't give you any scripts. I gave you very clear instructions to follow, not scripts. Instead, you did your own thing, made up your own instructions... Good. That wasn't

Ooops...my bad. I was not thinking clearly about spur visits. OpsPro will automatically include all the spurs at City-C thus Train-B will make the stop at City-C and then make a single "move" to leave

Scott....I like it but I have some questions... 1) When Train-B visits City-C, it seem like Train-B must include each City-C spur in the Train-B route to ensure that cars are placed properly in the

Roger, It is possible that the JMRI installer did not remove old versions of some components. Try doing a clean install: Use the Windows Control Panel to remove any JMRI versions. Manually check

Dan and Martin, ... unless the A/D tracks are staging.? I have three westbound passenger trains all departing from the same staging Location, with similar consists and train lengths.? I want to know

Ok Klaus. Thanks. Mario

I have noticed that after a fresh start.. with or without reboot of Pi.. I have to switch track power off/on at least once before any throttle data is actually at the rails.. even though power is on

that's kinda what I gathered from reading the manual. So an operator builds a train from the switch list, hands it over to the nest operator that takes it to the next city and drops the train off on

Martin, Most would agree that you and your operators should decide which arrival and departure tracks to use rather than the program.? Here's the link to the help:

The error message below indicates that there’s a problem accessing a library that JMRI needs. It’s usually part of the JMRI distribution, and lives in the “lib” directory within JMRI. Not sure

The error message below says that the "Roberts Layout31.xml” file in the "D:Layouts JMRI” directory could not be read because the name “LT11 DS TR” was defined for two different things. One is

Ken, Will not work in PE mode. I can add a regular turnout in PE with no problem and I can get the double cross icon window to show up but the "Add to Panel" button is grayed out and will not do

I am unable to launch this latest version of JMRI Decoder Pro. I downloaded the latest version and it seems to install OK. I have also installed the latest version of Java. I am running Windows 10 on

Hi JMRI friends, Does anyone know why the throttles freeze for a short period and then come back.? I am using JMRI 4.10 on a new dedicated motherboard and SSD with 8 Gb of memory.? JMRI links to an

Hi Dave & Cliff Tried to understand Dave's scripts... but I'm not a programmer so scripts are not of much use. First off.. Connection Prefix is "L" for Digitrax on both computers. I have modified both

This is my first go at JMRI. I have loaded all my cars, locations, made 2 train and 2 routes. The build works just fine. I have departure and arrival tracks at 3 of my main terminals. I am wondering

Perfect Dave.? Thanks so much.

hi there is there a decoder pro definition file for massoth decoders thanks? keith

Paul, You can flip between PE and CPE. So flip to PE mode and add your double crossover. Then flip back to CPE. -Ken Cameron, Member JMRI Dev Team www.jmri.org www.fingerlakeslivesteamers.org