开云体育

Hi again Dave I'll get that downloaded now. Something must have been niggling with you for you to go back to this.and I appreciate what you have achieved by doing that. Thanks again Fraser

This is not JMRI specific, but is more general to the model railroad electronics interest. ?So moderators, please excuse me if it is out of bounds.... I am just sharing information with the group

Alan, all decoders have railcom enabled, and? I read CVs with no errors. I have the timeout when I write a CV. No problems on programming track.

Thanks for the ideas. I just got back from the show and will set up my test track (which is what I was trying to use) tomorrow morning and look that these possibilities. All I was doing was opening

To do that it is presumably using Railcom. Does the decoder you cannot read have Railcom? I suspect it doesn't. What happens if you try and read it on a programming track?

Hi Tim - I've read that page a couple of times, it sounded promising! I get to the part where the throttle window is supposed to open; but it does not. Thanks - Jon

Yes, I can.? Moreno

Hi Craig, ?? There is a detailed help here which explains how Groups.io handles bouncing emails :- ?/static/help Regards John Russell

See how i have mine setup. It may help you: I have one location called "Northeastern yard" In that location?I have tracks designated as below: 6 classification tracks designated

You can read a CV value in POM mode? Mick ________________________________ Mick Moignard m: +44 7774 652504 Skype: mickmoignard Sent from my iPad, so please excuse the typos.

Thanks for the response. The IP address shown is not for my IPS (calbeone.net). I will attempt to contact cableone.net. Craig

It means that IP address has been marked as being used to send lots of spam, so it’s turned off for email purposes. How your email got involved depends on whether that’s actually your IP address,

I tested Zimo mx630P16, Lenz Standard+? 10231-01, Esu lokpilot v4 dcc and I have the error with all decoders. Track is connected directly to the "main track output" of the Z21. With every decoder CV

Ok i will try that Tony

There are numbers in that column. I never clicked ‘move’ or ‘terminate train’ which the manual says puts the new locations in the car/engine database . I created test trains to test out how

Jon Look at http://jmri.sourceforge.net/help/en/html/hardware/raildriver/index.shtml Tim

Are you in edit mode and not actually reading the decoder? Mixk ________________________________ Mick Moignard m: +44 7774 652504 Skype: mickmoignard Sent from my iPad, so please excuse the typos.

Tony, BTW, in your Cars window, there's a column marked "Moves", if you've never moved or terminated a train, the car move counts should all be zero. Dan

A friend of mine picked up the RailDriver console at Goodwill for $6...? Has anyone used one recently?? My CentOS Linux system recognizes it, and JMRI detects it, but it never launches a throttle

Moreno, ? ? You need to tell us what decoder you writing to and if you have a programming booster. Roger