开云体育

How does one update the ED app on phones? I have several dumb phone used just for ED no cell service Kurt

Oh, the icon has changed. Nice Dave

Dave, I have just registered. Thanks mate. See you there. Dave, dlowe30971@... Mobile: +61 (0)432 493 477 ________________________________ Sent: Wednesday, 1 August 2018 2:25 PM To:

Sorry that went totally wrong.

Thanks to All, back to Running trains

Hi James. The answers are embedded in your message text

Dave, Never mind.? I got it.? Thanks. Ron

Dave Sand, could you help me get the panel file you revised uploaded to my computer.? The option to copy it is grayed out when I try to copy it.? Thank you, Ron

Thank you very much for your swift replies. Firstly, to respond to Dave - I did not want the trains to keep running in a loop, as I wanted to test their ability to stop: I want them each to run one

After following Ken's instructions (with reference to the Dropbox page), click on the existing profile in Preferences->Config Profiles and use the "Copy" button rather than the "New" button. That way

Steve, Thanks for the feedback. I suspected that it was protecting against unknown trains. Not that they would respect signal indications. :) Dave Sand

Ah Dave Belt and Braces. If an unscheduled train is in the section it will still show a stop. Think a young or old manual engineer looking at the mast. "No dad/daughter/over served friend, you havent

Steve, I noticed that you included the direction sensor for the section prior to the mast in SML along with the normal direction sensor for the section protected by the mast. I am curious about its

Hi James and Dave This is correct. Steve G.

Hi James This could be bug, I would have to check. Steve G. -- Sent from my Android device with K-9 Mail. Please excuse my brevity.

Hi James Firstly I made all sections consistant in direction, so the transit would show all Fwd, it makes setting the fwd and rev sensors consistant and therefore which sensors should be checked

James, I don’t have time right now to fully analyze this but "Reset when Done" has to be checked if you want to have the train keep running around the loop. If it is not checked, the train will

To add further information: when I terminated the train and re-created a new Active Train using the exact settings shown in the screenshot, the behaviour was different: the train accelerated to a high

Hi All, I have managed to get my turnouts operating from my iPad. It was knowing where to start from:- Panelpro Tools Tables Turnouts Click on the ADD button bottom left. Typed in the

Thank you for working on this: that is most kind. Firstly, in response to Dave, here is a screenshot of my train settings: /g/jmriusers/photo/65718/0?p=Name,,,20,1,0,0 As you will