开云体育

I know I'm dragging this up from waaaaay back, but I've been hanging on to a bunch of TracTronics SECSI boards and am looking for a more modern way to run them. It looks like there was once some

The very recent update for DecoderPro definitions for SoundTraxx (TSU2) doesn't appear to have made it into 4.8. I think this means that the update needs to be reloaded after installing 4.8. Or am I

I have been running over 20 frog juicers for over 2 years and no problems what so ever. David

Fraser I have had a working layout for 4 years with 4 duel frog juicers 2 for reverse loops and two Crossings at grade with no problem. There only draw back is you cant run DC over them and since I

Here is a different troubleshooting procedure for serial ports on Linux: Open a Terminal window and put in this command EXACTLY (except for the double quotes): "while : ;do clear;ls -lt

Yes, the SPROG is actually a basic DCC packet generator with a booster and a CV programmer. To keep cost and bulk low it was designed so much of the code and user interfaces (command station code,

Dick, Thank you for your prompt response. I do have a fairly large layout, with BDL-16 block detectors, SE8c signal drivers,switch controllers of various types, etc. I noticed that it would sometimes

Fraser, I downloaded your file and it validates just fine on 4.8. It does, however, blow up on turnout "MT " (with a space). Dave Sand

ok so that didn't work. error message: https://flic.kr/p/WNTeQ7 https://flic.kr/p/WNTeQ7 setup screen: https://flic.kr/p/X1cAYG https://flic.kr/p/X1cAYG dmesg screen: https://flic.kr/p/X1cNjY

I installed 4.8 and everything seemed to work fine until I clicked the "finish" button, then it says it can't connect and makes me go back. I did everything in this page as instructed:

Ken, Don't forget the distinction between 'Signal Blocks' (logical) and 'Detection Blocks'. (hardware) I forget which one is called 'O Block'. A signal block may contain multiple detection blocks.

Hi Bob Thanks for looking at this but having looked at the schema for matrix signal mast and checked which line it was that was causing the problem it is the bit I've copied that is where the problem

I can't find your email. You can email me at mikeca@... or let me to get the file to you. Thanks, Michael Carney www.papacarney.com

Hi, I am new to the group, and unfortunately have a problem I am hoping others may have solved or at least get advice from those more computer literate than myself. I did not see a similar issue in

Hi Dave, For some reason my file upload button is not on the file screen. It was there earlier but it is not there now. Any suggestions on how to get it back. I will try and emailing you my config

I don’t think that particular element is the problem. For one thing, it’s a regular mast: Matrix masts are (I think) stored as <matrixsignalmast> elements. Could you show an example of that?

While I agree that frog juicers can be used in cases where simple logic should suffice, that is not true in all cases. For example, I have several gauge separation turnouts on my layout, where dual

jmriusers@...> wrote:

Sorry, I didn't mean to ruffle feathers here. As to which "thread", I thought by replying to the immeadiate email it was obvious..thay's what I dislike about Yahoo..it disconnects story lines

Mike, Did you upload a new copy after removing all of the signal masts? I am not able to find it. The one from this morning is still there. When you copy JMRI to /Applications, are you selecting