开云体育

Thanks, I will see how I go. (It may prove easier for me to wait till you have moved ED to AndroidStudio.) Peter ---In jmriusers@..., <mstevetodd@...> wrote : Thanks, Peter. Those changes

Billybob, Thank you for confirming my observations. I am planning of extending hardware bits using the shift register method and I am now a bit worried that C/MRI operation of updating changes may

P.S. here is a screen shot of 4 Lights sequentially swicthed to ON [41 54 01 00 00 00 00 00] Transmit ua=0 OB=1 0 0 0 0 0 [41 54 10 03 00 00 00 00 00] Transmit ua=0 OB=10 3 0 0 0 0 0 [41 54 07 00 00

Sorry, but neither of those is right. It sounds like the LI100’s USB connection isn’t being properly being seen by your Mac. Perhaps there’s a driver that has to be loaded? Bob

I have missed something, and cannot see what. In one spur (IGA Dr 1), I have a reefer that is scheduled to be picked up (which would make room for a new car), and I have a reefer in a yard that is

Hello name?, That 303 error message, that can only be generated if the command station responds to the system with a message that says the command isn't supported. You said in your original message

Mike R,

Tim, Can you open up the preferences and then select the "Defaults" panel from the menu on the left. Make sure that everything is set to either the Z21 or Z21XPressNet connection (it shouldn't matter

Once again I tried searching for this one and failed. So please bear with me if this has been asked previously. I want to print the cars at just one location. So I go to that location, and under tools

Here's the help link to staging tracks: http://jmri.sourceforge.net/help/en/package/jmri/jmrit/operations/Operations.shtml#Staging

Geoff, Yes, that is a correct interpretation of the C/MRI protocol. The C/MRI protocol does not have any message formats which deal with only one output, or only one input. It only has formats which

Dan, Problem solved, but I am confused. Turns out the track had more cars than the route was set for. Same with the other missing tracks. I mistakenly thought that the program would use however many

Dan, Well, my idea of deleting one of the missing tracks and then copying a good track to that track name did not work. I deleted track 2 which was one of the missing tracks. I copied track 1, which

Dan, Okay, I will go try that. Norman

Hi Bob, Although everything with JMRI-CMRI interface is working fine, I have one more question. I have been examining the messages sent using the CMRI Serial monitor. It appears to me that when one

I have 4.2.1. JMRI and am having problems programming CVs 200-500. I have a PowerPro system (not a Power Cab). How do I get these higher CVs programmed. I have the lastest EPROM on my system, which is

Normand, The train build report will show you all 50 tracks and why the 7 weren't available. It doesn't matter which staging track you choose. My guess is that you either have too many cars for the

Norman, The train build report will show you all of the tracks available and not available from staging. Just try to build the train, and press "Cancel" for the staging track selection. The build will

Hello all, Dave, thank you for your reply. I installed the SiLabs CP210x drivers without issue some time ago and, I have no issue with the USB Interface communicating since I can use the Withrottle

Steve, FYI on my Android 7.1.2 device there is no "smart network switch" setting under the "Advanced Wi-Fi" menu. My solution to the problem is to enable Airplane Mode to turn off the cellular