Alberto,
Sounds like the sensors in the sensor table are not matching the BDL and the
LT5 indication. So if you only have one thing on the track (loco) and it is
moving, do you get a change in the sensor table (click on the column header
for active/inactive, it will sort them so any active move up) by seeing a
sensor change to active when it enters and leaves the block?
Next trick is to open the LocoNet->LocoNet Monitor, it will show the
traffic. To simplify things, slide the loco between two blocks, this should
give messages of a sensor going active and inactive. Let's use this to
figure out which sensor should be changing.
-Ken Cameron, Member JMRI Dev Team
www.jmri.org
www.fingerlakeslivesteamers.org
www.cnymod.com
www.syracusemodelrr.org
Ken Cameron