?

Alberto,

?

Sounds like the sensors in the sensor table are not matching the BDL and the

LT5 indication. So if you only have one thing on the track (loco) and it is

moving, do you get a change in the sensor table (click on the column header

for active/inactive, it will sort them so any active move up) by seeing a

sensor change to active when it enters and leaves the block?

?

Next trick is to open the LocoNet->LocoNet Monitor, it will show the

traffic. To simplify things, slide the loco between two blocks, this should

give messages of a sensor going active and inactive. Let's use this to

figure out which sensor should be changing.

?

-Ken Cameron, Member JMRI Dev Team

www.jmri.org

www.fingerlakeslivesteamers.org

www.cnymod.com

www.syracusemodelrr.org

?

?

?

?

?

?