开云体育

This email thread has great timing. Have 3 of these awesome rigs and a previous one lost the cap. Sent it to a friend hamrepair.com in SA Texas. Just have that failure again, now I'm inspired to fix

The 7000 manual says for an amp relay not to exceed 16 volts @ 200mA. I did work on a Clipperton a few years ago. I don't remember the current draw but I do remember it was more than 16 volts so you

Thanks. Ed KE6SU [email protected]> wrote:

The IC-7000 has very small relays that do the switching and they are hard to change. I used the MFJ ARB 704 interface box with an Heathkit SB-200.

Ed, I don’t have specific information, but an area of concern is the IC7000 circuit that switches the amp from stand-by to operate. The voltage/current requirements of the amp might exceed the

Anything special about connecting a IC-7000 to a Clipperton-L Linear?

Hi, I'm looking for the ic-7000 DSP unit spare part Thanks and 73, Stefano

Craig,? ?I've been doing surface mount and through hole repairs for years (40 +). you? can glue the trace back down with superglue but use an accelerent, epoxy will work, but you have to wait for

Hi, When the two 12v tants are nearly all SC after 20 years, if one holds the power on button in for too long this takes the 4R7 resistor on the underside of the logic power supply board. The

This is very insightful and inspiring, Craig. Thank you for sharing your experiences. ismail [email protected]> wrote:

Hey everyone, I am new to this group and I am in the process of repairing a few IC-7000s.? One was given to me by my grandfather and the other was my dad's that failed and was deemed irreparable due

[email protected]> wrote:

I appreciate all the instructions and advice from Andrew, JD and James. It has been a few days since I last did any testing. So far, I have found nothing that is causing the output power to be so

Icom 7000 and 7300 as I have both work down to 12V reliably. They get fussy at? around 11.8V.? ?That however is measured at the rear panel connector.? Long wires and fuse issues even at 13.8 can

I checked power supply connections. Good. I came across 2 patch cords that had gone south. One was new a year ago. The radio is working as it should. Thank you to all who replied. Now to play on hf.

Hi Most Icom radios will not operate on low voltage, i.e. 12.5V lead acid, always feed with 13.8V min. Yaesu and Elecraft will go down a bit. KR Andrew Sent: 03 February 2025 15:31 To:

The IC-7000 is VERY voltage sensitive.? I had the exact same problem.? The very nice and competent gentleman at the St. Joseph Icom Service Center set me straight.? The 7000 needs 13.6v.? Use a

Try into dummy load. Try lower power. Bob W4JFA [email protected]> wrote:

check the fuse holder connections.. vk3zzs geelong [email protected]> wrote:

Ok thanks to Jim as well Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Saturday, February 1, 2025 3:49:37 PM To: [email protected] <[email protected]> Subject: