开云体育

Agreed, Milo! Sometimes I feel my old vacum tube powered radio is just like a lit 5W lamp, compared to the 7k. I can’t say I use that much my 7k, but, I can feel it very hot after 30 minutes at 50%

Hi Bill, Just curious how long (over all, not that session) you have been using it, and if you were running full power, or close to it. It has always been my opinion, not shared by all I might add,

Which circuit board has the problem? Do you know more details about what was damaged? How did the static discharge happen? Steve, W3AHL ---In ic7000@..., <iz0abd@...> wrote: Hello, my

<http://www.icomamerica.com> www.icomamerica.com or <http://www.icomuk.co.uk/> http://www.icomuk.co.uk/ contact Michael Hudson [michael@...] he take care about parts there But in my

Hello, my IC-7000 died because a ES discharge. The guy of the service said me to not repair it but I'd like to try by myself. So, does anybody know where to find spare parts of IC-7000? I mean not the

With three failures in a year, I would look if there is something about your installation that could be a problem. The common problems in my experience are: Intermittent shorts or opens in feed lines.

I previously had the HF pre-amp FETs short out. ICOM was good about fixing that quickly, as well as replacing a "noisy fan" (? - never noticed it). Second time I sent it in for what I was considering

Welcome to the club :-) When it happened to me, I sent it off to the local ICOM distributor, who repaired it under warranty and promptly returned it to me with no hassles. It is disappointing that the

The Winlink system has the ability to receive and forward position reports into the APRS system. Just set up a Winlink account and load RMS Express software. The software uses a sound device mode

Just to throw my 2 cents in about the IC-M802. The radio is a boat anchor. Then you add the speaker and the control head, both are plastic and neither of which weigh very much. However, this was

There are several problems: There's nobody who will _receive_ an HF DSC call on the ham bands -- it doesn't exist as a "standard protocol", and there are no standard "emergency frequencies" on the ham

My -7000 just produced a wonderful *pop* sound halfway into a Dit-Dit, and then billowed smoke. Great way to kick off 2014 and work the ARRL Centennial QSO Party. This will be the third time it makes

i always use ebay only ever had one problem left it three weeks then claimed the moner back no problems

I have had great luck on eBay. I know several others that have had similar success. I guess we are 'lucky?' When I shop, I go to eBay FIRST, then Amazon SECOND. My wife does the same, but favors

I can see that this old dog has a lot to learn from the smart dogs, thanks WB5EAT ________________________________ To: ic7000@... Sent: Tuesday, December 31, 2013 6:54 PM Subject: Re:

Since the IC-M412, which is?a marine VHF?and a marine SSB was mentioned, why not just get the IC-M802, which is a marine SSB?

APRS is NOT DSC (Digital Selective Calling). The IC-7000 doesn't do the DSC protocol. You need a marine radio, such as an IC-M412.

You can do 300baud Packet APRS on 30m. And have the GPS sending your location.

Never an issue here with ebay since 2003 ? We are pretty much protected Brian Mackey KC1MAC Hams don't let hams get stuck on 2 meter repeaters! From: BT Yahoo!?2013 <robert.farey@...>

I do business on eBay occasionally and have had only one incident where I had to get eBay customer service involved. I purchased an EF Johnson radio which was suppose to be new, with a specific