开云体育

I'm bringing this thread back to life because I'm having a similar problem with my IC-7000 using the 9600 baud rate. I have a DigiRig Mobile and the idgiRig 6 pin DIN cable, fo rCAT control I am using

Hi Tommy not easy to find these type of issues, check dc voltages around the final circuit, coupling capacitors and switching devices. Good luck james

Make sure that all of the power connections are clean and tight. If the fuse holders are still in your power cable especially make sure that they are clean, bright and tight. Also if you have a dummy

Hello all, I have a problem I'm hoping for help with. Three different times last week, my IC-7K shut off when I keyed and then immediately restarted. I've never previously experienced this in the two

James, All functions work on all bands for receive. Because of that I believe the filters and switches are functioning properly. There is no SWR, power meter or ALC meter for HF transmit at any

are there any indicators like tx power level and check current draw. is the power being throttled ? Any heat being dissipated due to current draw? look for hot spots

Hi Tommy check the components within the boxed lines in the below picture . make sure the correct LPF is active for the selected band in use. James

I purchased the radio with this symptom. ?Everything seems to work for VHF/UHF. ?This means the driver is functioning. ?When I trace the HF signal with a scope past the driver I do see a signal

Hi Geoff nothing on the S-meter, but occasionally the unit starts to splatter high levels of audio when warmed up - nothing recognizable just splatter. The 8v regulator underneath the main board gets

Good work James. Did you see anything on the display like a reaction on the S meter. Won't be surprised if not as some of the clocking inputs to the codec chip come from the clocking I/O pins of the

Just out of interest i would like to compare settings just in case mine are too far out. If anyone can compare with their settings that would be much appreciated

Hi All Confirmed the audio circuit from IC551 to speaker is ok by injecting 1khz tone at various points after IC551. Now waiting for the replacement ic551 to arrive. will keep you updated

This just posted on *IC-7000 no rx and no sound out from speaker* topic. "I think this Topic has got crossed over somehow *[IC-7000] Re: Front panel troubleshooting* which happened around Nov 4.

I think this Topic has got crossed over somehow to *[IC-7000] Re: Front panel troubleshooting* which happened around Nov 4. There are a number of replies that have not appeared here but on the Front

Hi Geoff Good idea. At least it will verify output circuits. Will let you know how it goes . James

James can you capacitively feed an audio signal, no greater than say 3Vpp, onto the pins 25/26 and see if you can hear/see any reaction. Monitor the signal at these pins with a CRO to see if its

Geoff Ditto: educational not annoying Kurt KD6LZV

Hi all I checked ic551 pins 10 - 14 and only pin 10 has the 24mhz clock, 11-14 are 0v no activity at all- even from a power off to on state. I ordered a replacement IC from China - will take a week or

Geoff, These posts on troubleshooting are interesting, not annoying. They're good reading. Bob W4JFA [email protected]> wrote:

I recently bought an IC-7000.? During my very first QSO (on QRP 70cm CW) my QSO partner (Chris GU3TUX) noticed frequency jumps at the start of each of my transmissions.? He kindly informed me, and I