开云体育

Andrew,? Are you able to correctly adjust all of the Drive/Final Idling Currents?? For adjusting TX power output, using the correct mic audio level and frequency as specified in procedure is

yes all voltage supplies where checked

Hi, did you test the transistors Or did you just change them hopping that this would work?, did you test for voltage supply on the transistors, Dave wrote:

Guys is there a way i can check the filters. My rig Rx just fine but now out put. 1) the main transistor has been replaced 2) the small transistrs have been replaced (for the transmition) 3) the rigs

The second new 7000 I bought started to have screen problems.? It would show static but never cut off.? I send it back under warranty to Icom twice but it never misbehaved while there.? I got it

https://www.eham.net/classifieds/610710 Not by me, I'm just sharing. Danny

- need to dig into atu icom connector operations to trigger ant from radio and radio from interface A good description of the _START and _KEY signal interaction and status between the Icom Molex

i DON'T BELIEVE THAT THE ic-7000 is compatible with the ATAS (Yaesu). The Yaesu radios have a DC output voltage that changes level to drive up and down or stop. The SWR meter and control circuit in

I have used Icoom AT180 tuner with the 7000, 703 and 706 for many years with great success! 73 de K9UTQ

Thanks to all who replied Larry R., Allison, Wayne, Dom, Rick, Max, John, JD, Rubie, and Larry M. What a group and lots of great info. I think I have come up with a solution of either a tuner such as

I think I have resolved the issue.? I noticed there was oscillation on the 3.3v line on the DDS.? I added a 10uf electrolytic cap to the 3R3V pad above DDS R9 and ground to stabilize the voltage.?

I've been using the LDG AT-7000 with my IC-7000 for about 10 years. The antenna is a Comet UHV6 HF with loading coils for 40, 20 15 and 10. I bought a cup holder mound for the control head unit and a

I have the AT200Pro with the interface cable. Can't get it easier with my mono-band whips I use

10 years my mobile set-up? has been an IC7000 remote in the trunk under the floor in the tire well. I use a AH4.. output of the AH4- is 8 inches of RG8 minus shielding to the base of a 3/8"-24 CB

I have an LDG AT-100 Pro, which works well with my IC7000, I made an interface cable. I believe one can be purchased as well. Robie AJ4F

The AT-7000 is obsolete and NLA. Parts are not available either. But the later model tuners will work just fine. I have used the MFJ 939 I with good results. The AH-4 and compatible tuners will work

LDG AT7000? its designed for the IC7000. -- Allison

I have used an AH-4 tuner and it works very well, although I did not use mine mobile. I had bad luck with an MFJ auto tuner (forgot the model) but it would not allow the fan in the IC-7000 to run

Hi Phil, I am also using an IC-7000 in my car together with an LDG AT-100 pro antenna tuner for HF bands. The tuner does quite a good job tuning my mono band MFJ whips. Best 73s, Dom DL5EBE Am

The AH4 with a 102 “ whip will work great. Be sure to double insulate the feed wire from the tuner to the whip. I used heavy gas line hose from an auto parts store. Here is a safety tip for mobile