开云体育

I've been using the LDG AT-7000 with my IC-7000 for about 10 years. The antenna is a Comet UHV6 HF with loading coils for 40, 20 15 and 10. I bought a cup holder mound for the control head unit and a

I have the AT200Pro with the interface cable. Can't get it easier with my mono-band whips I use

10 years my mobile set-up? has been an IC7000 remote in the trunk under the floor in the tire well. I use a AH4.. output of the AH4- is 8 inches of RG8 minus shielding to the base of a 3/8"-24 CB

I have an LDG AT-100 Pro, which works well with my IC7000, I made an interface cable. I believe one can be purchased as well. Robie AJ4F

The AT-7000 is obsolete and NLA. Parts are not available either. But the later model tuners will work just fine. I have used the MFJ 939 I with good results. The AH-4 and compatible tuners will work

LDG AT7000? its designed for the IC7000. -- Allison

I have used an AH-4 tuner and it works very well, although I did not use mine mobile. I had bad luck with an MFJ auto tuner (forgot the model) but it would not allow the fan in the IC-7000 to run

Hi Phil, I am also using an IC-7000 in my car together with an LDG AT-100 pro antenna tuner for HF bands. The tuner does quite a good job tuning my mono band MFJ whips. Best 73s, Dom DL5EBE Am

The AH4 with a 102 “ whip will work great. Be sure to double insulate the feed wire from the tuner to the whip. I used heavy gas line hose from an auto parts store. Here is a safety tip for mobile

I run a 7000 with the AH4 tuner and 102” whip(mobile). It works wonderfully and I’ve been running this for near 5 yrs now. Of course mobile doesn’t quite compare with a good 100 watt base and an

Greetings and Happy new year. I recently needed to change vehicles and I am looking to scale down the whole setup inside and outside the vehicle. I had a tri bander for 2m, 220, and 440 and simply

Hi, I'm having an odd issue with my IC-7000.? It has an odd behavior that it will loose RX and TX when changing the frequency. Power cycling the radio allows it to come back but moving the dial will

My IC-7000 mike cord has developed an intermittent.? I see plenty on the e place for $8.99.? Is there one supplier I should prefer or any I should avoid?? A better place to buy one? Thanks and

Be very careful with the ribbon cables since the 7k has been around for so long the plastic ribbon cables are usually very brittle.

The display has become erratic on my 7000. Powers on and operates properly. But after being on 30 minutes or so the display will blank although the radio continues to operate properly. (Installed

Forgot to add get power at the J101 and then also low at the driver and the finals . But it as low as if not txing

Reception is fine but only transmits about 3 watts on uhf nothing on 2 meters and nothing on hf. the two predrivers havebeen replaced the main driver has been replaced and all the other drivers still

thank you Steve that looks correct. i have found the solder broken in the pic i sent. ok thats not the problem. I have tested the rig and fond no out on the CP951 .and fond the small solder

I recently acquired an IC-7000. Had several Icom units before, never 7k, but I am excited by the “ahead-of-its- time” features. After initial set up the output became erratic - screen fuzzes over

It was Danny.