开云体育

Hi folks; Just a couple of questions for those among us who use "modern" DC powered equipment, since I labored my last 34 years as a tube rig user, and never had to worry about 12 volts except for low

I'm in this camp too, except for one thing. If the "feature" is there, it should work. Period. Like you, I don't think it has a good use at all, and any clock that doesn't have at least a 60 cycle

My clock is off 3 mins. after 15 months. Monroe AF6JC

Back in the late 1950's I had a Hammarlund receiver with a clock. -Tom, W3TLN

There's a clock? (just kidding) Terry KF5WBG From: ic7000@... [mailto:ic7000@...] On Behalf Of Alex Netherton Sent: Wednesday, November 06, 2013 7:26 PM To:

Hee hee I couldn't help myself. I rarely even look at the clock on mine. 73 de kc4bo

It's been awhile since I looked at the schematic but I think there is a 38 KHz crystal in the radio for the RTC circuit. If there is no "padder" capacitor to adjust, the only solution is to replace

Alex, you *do* have a sense of humor. jd/K1TLV

What did Icom say when you called them? ---In ic7000@..., <davefox73@...> wrote: Has anyone else experienced a problem with the clock on the display losing time? After setting the time to

What did Icom say? Thank you, Brian Mackey - KC1MAC

From 1979, the time of my licensing, to May of this year, I never had a rig with a clock. Most had tubes. Does the rig work? Do you make contacts? Get good reports? Very sorry, but I fail to see the

Same problem here . I await any answer you may get because I have never pursued the matter but should have. VA3WU Rick

Has anyone else experienced a problem with the clock on the display losing time? After setting the time to WWV, I lose a minute about every two weeks and have to reset the clock. Rig is used as a base

Also remember to secure the extension cable, if used, with the small screw that was supplied. If rig will have a higher susceptiblity to RFI without it. Perry K4PWO Sent from my Galaxy S?III

First question: . . . Is the control head separated from the body of the rig? Second question: . . . If so, do you have ferrites on the control cable between the two? Third question: . . . Have you

Thank you for posting the update on your radio. I hope it gives you many years of enjoyment. 73, Jon... N7OCD

Out with the grounding cables and ferrites. :) -- 73 de Tony VK3JED/VK3IRL http://vkradio.com

Yes, so no necessary to do any reset: Bad installation behind the IC7000. Best regards, Ludovic - F5PBG.

On 5/11/13 12:18 PM, kb1rrx@... wrote: > > > I have an issue with =the display on my unit and hope somebody can give me some incite. I have had my 7000 for a couple of years now. A month or so

It could simply be a lack of RMS stations within your area. Also, propagation can sometimes be weird. I had one morning where all the highly ranked "local" gateways were inaccessible, and the only