开云体育

Well one thing for sure you won't be dropping a note complaining that your IC-7000 is running hot. LOL 73 Ken W5CGP

The "L" in LCD display is liquid. ?They can freeze which can damage the display. Keep the shack above freezing and you should be OK. Perry K4PWO Sent from my Galaxy S?III

I’d be a bit concerned that after a day or so of very cold temperatures, a sudden warm humid day might result in condensation inside the cabinet. Les K8LES

Temperature cycling is always a potential issue. You could always leave the radio running, which minimises the cycling. -- 73 de Tony VK3JED/VK3IRL http://vkradio.com

See file in files section called ' Fan mod, how it should be done for IC-7000.pdf". It is simple...

I have found this method to work very well to cool the IC-7000. Best one yet... Go to the files section and look for the file called.."Fan mod, how it should be done for IC-7000.pdf" It is

My shack is in a 10x16 Shed that is outside of my house. It is insulated but not heated when not in use. Anything I should be concerned about with my gear being out there? Anything specific to the

Regardless what speaker you choose, try it in different locations in the vehicle before you mount it permanently.? You will be surprised how physical location affects the sound.? Even a small

Haven't had an issue. Mine runs warm, but not excessively hot. The one in the shack has run 24x7 for most of the past few years. -- 73 de Tony VK3JED/VK3IRL http://vkradio.com

What he said. Same for 220 (US) and 440. KC4BO wrote:

If you have the default setup, the knob behind the volume is the squelch in FM and RF gain for other modes Perry K4PWO Sent from my Galaxy S?III

I don't know where you are, but mine has a 1 year warranty from Icom, and an added 2 year warranty from the merchant. Should allow me to "burn it in" in that time! Many shops allow you a certain time

Where is the squelch level and mode set at? ismail kt6ln alex.c.lawler@...> wrote:

Just to clarify: The FET on the small board is the driver (Q504). The pre-drivers are Q101, Q102. The first adjustment in section 4-4 sets the Driver idle bias. The remaining steps adjust the PA

I was operating the IC7000 on my desk when it emitted smoke. I quickly turned off and opened up to investigate. I confirmed that the pre-driver board was blackened, which according to web searches

The RCA and GE mobile speakers are also pretty good. * * * * * * * * * * * * 73 - Mac, K2GKK/5 * * (Since 30 Nov 53) * * Oklahoma City, OK * * USAF, Ret (61-81) * * * * * * * * * * * * To:

That's what I run mobile (1 for my 7000 and 1 for my 8800). I use the unamplified one and it will handle 12W of audio, it is very loud and very clear. You can pick them up unused for $5 or so at

Hi. Thanks for the replies. For some reason I am responding to msgs but they are not showing up. Perhaps as I'm a new member the moderator is checking my msgs before they are publically posted. That

As I remember it, the IC-7000 has a default setting which makes the "RF GAIN / SQL" knob act as an RF Gain knob in CW/SSB mode, and as a _squelch_ knob in FM mode. A flickering green light --

I'm using a R/S 10-w amplified-speaker. Works rather well, but don't know if they're still available. It's mounted on the top-of-the-dash 'dish', which I cut holes into to allow the audio & DC