开云体育

Go dig it out of the trash! Those are REALLY expensive on the internet!! BCV-KG

Raul, Does your D20 have the "newer" 6V6 amp? You can't tell the finish on the cab's is different unless you look REAL close. I just think it's odd. Did Hammond put more attention into Organ Console

Thanks Chris. I had a feeling this was a bad one. Will try to locate one in Australia tomorrow morning.

Steven, Thanks. There's a Grangers in New Orleans. Hittman

where did you see doug..... i played with him once.... (it was an open jam... but there were 2 organs... it was SWEET Dave "be keepin those b3's and leslies spinnin for years to come" Dan & Connie

But Ken, That means I'll have to run after the garbage truck( politically correct term is " Sanitation Engineering Vehicle") as of last Thursday. Or some trash picker got it. I've got another motor

Can anyone offer suggestions or advice on repairing oil wicks? What type of thread is this? Thanks, The Hittman

DARN! My wife just threw out a Hampton Ceiling Fan with speed control. Jimmy

Mike, Using the 251/351 on A-100 or any other organ with Hammond's "stereo reverb" (A-100, M-100 and E-100 + others?) puts amplified reverb sound on the Leslie cabinet through a separate amplifier and

In the old days I would have used tape, nowadays I would use self-locking plastic cable ties. The adhesive on tape tends to turn soft and make a gooey mess, cable ties are neat and mess free. I've no

Jeff, There is a picture of a simple mixer circuit in the files section of the zone's web site http://groups.yahoo.com/group/hammond_zone/files/Rvb2Leslie.jpg. You can use this on A-100 to mix reverb

I would like to know if anyone can help me design a motor speed control switch that acts as an expression pedal (speeds up as pedal is pressed, slows down as pedal is depressed)rather than just on/off

A 26-1 kit is for connecting almost any organ with internall speakers to a 147 type leslie. I have 3 of these kits. Many were sold to hook spinnets to 125's. Ron Bell.

Man, Ken, I'm thrilled for you. Even though the finish is a little different, you now have the same setup that came out of the factory! We have got to see this thing when you get her shined up. As

Raul, Excited...it doesn't SHOW, does it? Anyway, we can get on with that condo / resort development, now. I think I just added about 10 more units! Well, I got her stood up next to my BCV, now. After

Jeff, I think Vintage Hammond has the best prices, last time I checked. Goff and everybody else has them, too. Trek's prices are usually higher than their same merchandise through another dealer. 26-1

Jeff, If you had a 251 Leslie, you'd be all set. They were designed for Conn organs, and have a separate channel for Conn's string sounds. This uses a separate wire in the cable (the one used for B+

Jeff, I'm sure you just jiggled some tubes loose in transit. With the organ off and the tubes cooled down, pull the back off and move the tip of each tube gently in a circle about 10 times. This will

My daughter found it on the internet and gave it to me for Christmas. I saw it on there also a month or so before and kind of hinted it would be a great gift. I think it may have been on the hammond