开云体育

Good afternoon to the group, I have for sale a W4RT one big punch kit for the Yaesu ft817 family of radios using the supplied MH31 microphone. This provides speech processing that is missing from

Sharp side cutters.

Star Dos - I found your earlier post from 2021 about this /g/ft817/message/114244. How has your replacement performed over the last two years? I see in the 817ND service manual Yaesu

How did you cut the mounting legs of the encoder?

Rubbish! Wen I replaced my worn out encoder I carefully cut all the data connections and the mounting tabs, removed the encoder then carefully removed the soldered pin remains with a small tipped iron

You cannot simply cut the legs off. The encoder has two large mounting lugs that are soldered to big copper pads on the pcb, and you cannot just cut these off without causing damage. I highly

Thanks, I see Digikey have the Bourns encoders. I've not dismantled the radio to inspect it yet but is it possible just to cut the decoder off it's legs then remove the legs individually? I'm not

Dave, When in menu line 9, pressing the "A" button will change the icon at the bottom of the display to show your choice.? You cannot reduce the output to zero power, the lowest is one watt. The

I am setting up HRD on my 817. Every time I press the "A" button I can't seem to get the power out as 0. I press the "A" button but stays in s meter reading. Any help would be appreciated -- *73's de

Instead of the Yaesu encoder, I recently replaced my encoder with a Bourns PEC11L-4220F-S0015-ND encoder. These are 15 PPR, 30 detent encoders with a reliability rating of 100,000 cycles. The only

Hi Nick, I got a replacement from yaesu, not very expensive at all. When changing the select pot make sure that you remove the battery before doing anything else and replace it last. It's not a hard

Hi On my 817ND the multi function rotary encoder occasionally tunes the opposite direction and feels very loose. Can anyone recommend a suitable replacement? Thanks & 73 Nick

as i am fitting the side protection handles, i had to open the radio and have a look at the Final Board, and i am Happy to find that it has got the New Style Fet Board Fitted, and i also contacted the

Hi Matt I haven't tried this myself but I have seen others punch small holes for the screws in the original soft case then screw on the rails with the radio already in the soft case. Neil G7LHA

New subscriber, new FT-818 owner, first post. I got the PortableZero rails for the 818, and need some recommendations on a case to fit the rig in this config. Other administrivia (key, RG-316,

Hello Pietro, a while ago I had the same problem. I was ready to dismantle the radio, before that I did a full reset. eureka, the radio was fixed. Hope this help, vy73 ciao Bernie DF4NR

There should be several relay clicks between 160m and 10m, and the clicks should be quite audible. Are you powering off battery or the dc input at the rear? What voltage are you feeding into the

Ok i check and control the ground contacts. It is always a good idea. This is the first time i open the radio since buying it. There aren t accessories ( filters etc ) I noticed that the relais do

Try switching bands several times, I understood that sometimes the relais get stuck/dirty.. Dick PD0DF

Have you ever opened up the radio or modified or repaired it?